Philips CD145 During the conference call, External call is put on hold automatically, Call again

Page 22

During the conference call:

1Press to put the external call on hold and go back to internal call

•The external call is put on hold automatically.

2Press and hold to establish the conference

call again

Note

Any handset hangs up during a conference call will leave the other handset still in connection with the external call.

4.6How to find a handset

You can locate the handset by pressing on the base station.

All the handsets registered to the base will produce the paging tone and you can stop the paging by pressing on the handset or on the base again.

20	Using your phone

Image 22

Contents CD145 Register your product and get support atPage Table of contents Default settings Frequently asked questions Call in progress Phonebook Call log Redial list SettingsHow to change the remote PIN Use more of your phonePower requirements Page Use one of the following disposal options National recovery & recycling systemUsing GAP standard compliance Disposal instructions for batteriesElectric, Magnetic and Electromagnetic Fields EMF Telephone handset Base station Congratulations on your purchase and welcome to PhilipsWhat’s in the box Line cordTalk key Overview Phone Handset ACall Log keyPhonebook key Redial/Flash keyCall Transfer / Intercom / Conference Alphanumeric keypad GStar keyHHash key Program keyDisplay icons on the handset Event LED Delete keyBackward key Forward keyGetting started Connect the base StationConfigure your Phone Install rechargeable BatteriesSlide out the battery cover Place the batteries as Place the handset on Charging cradle NoteCode Country Default outgoing PressTip Direct dialling Make a call PrediallingCall is initiated Call from the call Log Display shows the last number dialled Call from Phonebook Call from the redial list End a callHow to use Intercom How to make a second call During a callHow to answer a Second call RecallAutomatically How to make an Internal callPress on the called handset Conference call is initiatedExternal call is put on hold automatically How to find a handsetDuring the conference call Call againCall in progress Mute/Unmute microphone During a call How to adjust earpiece volume During a callHow to store a number in the phonebook Idle mode Is shown on the displayHow to delete the entire phonebook How to access the phonebook Idle modeHow to edit the phonebook entry or Delete a number All the phonebook entries are deletedHow to access Redial list How to access the call logHow to delete the entire call log Settings How to set the time 1 PressHow to set the earpiece volume How to set the ring MelodyHow to set the ring volume How to activate/deactivate the keypad lockCurrent settings are displayed How to select recall timeHow to select dial Mode How to turn on/turn off the key ToneHow to access your voice mail number How to change the master PINHow to program voice mailbox Number New PIN is savedYour phone is reset to its default settings How to restore to default settingsUnchanged Press Enter your 4-digit PIN How to set answer delay How to turn off Answering machineHow to record your outgoing message How to delete outgoing message How to play Outgoing messageHow to select the default outgoing Message How to play Incoming messagesHow to remotely access your How to screen an incoming callPress and hold for two Seconds to delete all old messages New remote access PIN Is saved How to change the remote PINKeys Description Default settings Items Default valuesCommunication is lost during a call Connection Handset does not switch onPhone does not work at all Poor audio qualitySet-up Caller ID does not work properly Is blinkingAppears Call Waiting call cannot be answeredPhonebook entry cannot be stored Caller does not hear meNoise interference on your radio or television Handset is unable to registerUnable to perform remote operation