Philips XL3402 Getting started, Connect the base, Connect the charger, Charge batteries ! Warning

Page 12

4 Getting started

4.1 Connect the base

Place the base station close enough to the telephone and the mains power sockets so that the cables will reach.

1Connect the telephone line cord to the phone socket on the bottom of base unit and

the wall phone sockets.

Note

To use this phone, you need an RJ11C (CA11A) type modular telephone jack, which might look like the one pictured here, installed in your home. If you do not have a modular jack, call your local phone company to find out how to get one installed.

2Connect output plug of power adapter to the power socket on the bottom of base unit. Connect the power adapter to the wall mains

supply.

!Warning

The electrical network is classified as dangerous according to criteria in the standard EN 60950. The only way to power down this product is by unplugging the power supply from the electrical outlet. Ensure the electrical outlet is located close to the apparatus and is always easily accessible.

4.2 Connect the charger

If you have bought a multi-pack product, each extra handset comes with a charger and a charger adaptor.

1Connect the output plug of the charger adaptor to the bottom of the charger.

2Connect the charger adaptor to the wall mains supply.

4.3Insert the batteries in the handset 1 Place the two rechargeable batteries

(included) into the battery compartment.

! Warning

Verify the batteries polarity when inserting the batteries. Incorrect polarity may damage the product.

2Slide the battery door firmly into place.

! Warning

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. USE RECOMMENDED TYPE SUPPLIED WITH THIS PRODUCT. NEVER USE NON-RECHAR- GEABLE BATTERIES.

4.4Charge batteries ! Warning

The base station must always be plugged into the mains when charging or when in use. Place handset on the base unit or the charger and let

10

Getting started

Page 11 Page 13
Image 12
Page 11 Page 13
Contents US Telephone Page Table of contents Index Frequently asked questions Appendix Important Safety Instructions Important Safety Instructions Environment and safety Important information Your phone Redial, Cancel & Recall key Use to cancel an operation Microphone Volume up KeyVolume down Key Overview of the phone Earpiece Display Direct memory keysOverview of the base KeyDisplay icons Getting started Connect the baseConnect the charger Charge batteries ! WarningStandby mode Verify the signalLow battery warning Battery life and rangeUsing your phone Make a second call Answer a second callConference call Join a conversation Exit from Conference callUpper case input table Keys Lower case input table KeysUse more of your phone 6.1.3 Delete all memories Select ringing melody In standby mode Change the ringing volumeAdvanced features Register a handset Turn the backlight on/offReset your phone Select a baseBase selection Index Number Un-register a handsetSelect dial mode country dependent Temporary tone dialing in pulse dial modeSelect pause duration Pause duration Index Number11Paging handset Default settings Functions Settings after ResetQuick reference table for phone menus Index Number MenuTechnical data Range/Signal icon is flashing Handset does not switch onSecond call service does not work No dial toneAppendix Notification to the local telephone CompanyRights of the Phone Company Interference InformationNoise FCC RF Radiation Exposure StatementPrivacy Additional Information I.C. NoticeUSA/CANADA Service Center Terminal Equipment NoteRadio Equipment Do not attempt to repair or modify this equipmentIndex Un-register a handset 17 Upper case input table Page Koninklijke Philips Electronics N.V. All rights reserved
Top Page Image Contents