Datalogic Scanning NWGQ7 2Z78 manual Maintaining the Pegaso, Troubleshooting

Maintaining the Pegaso

Maintaining the Pegaso

With normal use, the Pegaso, Dock, and Four-Slot Battery Charger require no maintenance. For trouble-free service, observe the following tips:

•To prolong its life and avoid problems, keep the Pegaso clean. Use a clean, soft cloth dampened with a mild, dilute cleanser.

•Clean the display with a lens cloth or other soft cloth dampened with a mild, dilute cleaning solution.

CAUTION

WARNING

Never use a pen, pencil, or other sharp object on the display/touch screen. Use only the supplied stylus or plastic-tipped pens intended for use with a touch-sensitive screen.

Do not immerse the Pegaso, dock, or battery charger in liquid.

Do not use abrasive paper/cloth or abrasive/corrosive cleaners to clean the unit.

Do not use a sharp object to Reset; use the Stylus. A sharp object can puncture the button, disabling the reset function, rupturing the industrial seal, and voiding your warranty. Refer to Resetting the Pegaso on page 2-22

Troubleshooting

Refer to the Pegaso PRG for more information.

Table 7. Troubleshooting Problems, Causes, and Solutions

Problem	Possible Cause	Solution
	The battery pack is	Ensure the battery is installed properly.
The Pegaso does	not installed properly.
not turn on.
	System failure.	Perform a cold reset. Refer to Resetting the
		Pegaso on page 2-22.
During reset, the	Firmware persistent
terminal beeps		Re-download the firmware using the FUU in
	flash memory has
twice and stays		bootload mode. Refer to the PRG.
	been corrupted.
blank.
		Replace the battery. If the terminal still does
Rechargeable	Battery failure.	not work, do a warm reset, then a cold reset;
		refer to Resetting the Pegaso on page 2-22.
battery pack did
	The unit was removed	Insert the Pegaso in dock and begin charging.
not charge.
	from the dock while	The battery pack and backup battery require 4
	battery was charging.	hours to fully charge.

26 Pegaso™ Industrial PDA with Windows® CE