Panasonic KX-TCD400NZ Battery Charge, Battery Life, Fully charged, Display icon

Page 5

Setting up

Battery Charge

At the time of shipment, the batteries are not charged. To charge, place the handset on the base unit. Please charge the batteries for about 7 hours before initial use. During charging, the battery icon is as shown below.

Fully charged	During charging
(Flashing)
Display icon	Battery strength
	High
	Medium
	Low
	Needs to be
	charged

The handset, when powered off will be turned on automatically when it is placed on the base unit.

In normal use, the handset and the base unit should be powered on at all times.

Battery Life

Battery life is dependent on use and conditions but in general when using fully charged Ni-MH batteries (700 mAh): Talk time: 10hrs approx.

Standby time: 120hrs approx.

When using Ni-Cd batteries (250 mAh): Talk time: 4hrs approx.

Standby time: 40hrs approx. (Times indicated are for peak performance)

The batteries reach peak performance after several full charge/discharge cycles. The batteries cannot be overcharged unless they are repeatedly removed and replaced.

If battery life is shortened then please check that battery and charge terminals are clean.

For maximum battery life, it is recommended that the handset is not

recharged until battery icon flashes .

Preparation

5

Image 5

Contents Model No. KX-TCD400NZ ContentsBefore Initial Use Accessories includedSafety Caution Battery CautionImportant Information EnvironmentConnection Setting upBattery Installation Battery Life Battery ChargeFully charged Display iconSelecting the Battery Type Symbols Used in This Operating InstructionsReplacing the Batteries Please use only Panasonic P03PNi-MH or P03HNi-Cd batteriesHandset Location of ControlsHandset Display Wall Mounting Power On/Off Using the TelephoneSetting the Clock/Date Making a CallEditing the Dialled Number in the Redial List Making CallsRedialling Answering Calls Receiver VolumeAuto Talk Temporary Bell OffStoring a Callers Information PhonebookNumber Editing a Caller InformationClearing a Caller Information Dialling with the PhonebookPhone Number *1 Name Storing the Number from the Redial List into the PhonebookRegistering a Phone Number as a Hot Key Hot KeyDialling with Hot Key Clearing the Hot Key RegistrationTime Alarm Handset SettingsSetting Time Alarm On/Off Before programming, please follow steps 1 toRinger Option Setting the Ringer VolumeSetting the Ringer Pattern for External Call/Alarm Tone Option Call Option Display OptionOther Options Setting the Direct Call NumberSetting the Direct Call On/Off Key Lock Recall FeatureDialling Pause for PBX line/long distance service users Base Unit PIN *1 Base Unit SettingsDigit Base Unit PIN *1 5 Pause TimingHandset Initial Settings Function Initial SettingsReset Handset Digit Base Unit PIN*1 Reset Base Unit SettingsBase Unit Initial Settings Function Before Requesting Help Problem Possible cause SolutionConnections SpecificationsTechnical Information PIN IndexPage Page Page PQQX13638YA D0303NR1043 For your future reference