Panasonic KX-TG1850NZ Troubleshooting, Initial settings, Problem Cause & solution

Page 40

Useful Information

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.

Initial settings

Problem	Cause & solution
w is flashing.	LThe handset is not registered to the base unit.
	Register it (page 33).
	LThe handset is too far from the base unit. Move
	closer.
	LThe AC adaptor is not connected. Check the
	connections.
The handset display is blank.	LThe handset is not turned on. Turn the power on
	(page 11).
The handset will not turn on.	LMake sure that the batteries are installed correctly
	(page 10).
	LFully charge the batteries (page 10).
	LClean the charge contact and charge again (page
	10).
The display is dark and displayed	LThe handset is in screen saver mode (page 11).
items are very faint.

Image 40

Contents Model No. KX-TG1850NZ Introduction Feature highlights Making/Answering Calls Included accessories Accessory informationAdditional/replacement accessories Battery caution Important informationGeneral EnvironmentControls Controls and displaysDisplays Menu icons Menu Menu/feature IconSoft key icons Action Key Icon Connections Soft Action Key IconBattery charge Battery installationBattery strength Battery icon Battery replacement Screen saver modeTurning the power on/off Setting the date and time Example 330 PMRedial feature Making callsOther features Voice enhancerTo erase numbers in the redial list MuteAnswering calls Using the phonebook Adding entries to the phonebookCategories Finding and calling a phonebook entryErasing entries from the phonebook Editing entries in the phonebookOne touch dial Making a call using a one touch dial key Chain dialCopying one entry Copying all entriesGuide to handset settings Handset settings Sub-menu Default setting MenuTime settings Ringer setupAlarm Ringer volumeNight mode Setting the start and end time for night modeTurning night mode on/off Setting the ring delay for night modeDisplay setup Selecting the standby mode displaySelecting categories to bypass night mode Selecting wallpaperCall options Other optionsResetting the handset to its default settings Turning keytones on/offGuide to base unit settings Base unit Sub-menu Default setting Settings menuNight mode Setting pause length Changing the recall timeStoring/changing emergency numbers Selecting area codes to be deleted automaticallySetting call restriction Codes which you want the unit to delete automaticallyResetting the base unit to its default settings Using Caller ID service Category features for Caller ID subscribersCaller list Viewing the caller list and calling backEditing a caller’s phone number before calling back Erasing caller informationCall minder Storing caller information into the phonebookOperating additional units Registering a handset to a base unitAdditional handsets Additional base unitsCancelling a base unit Cancelling a handsetSelecting a base unit Increasing the range of the base unit Turning the repeater mode on/offHandset Multi-unit Operation Wall mounting 60 mm ScrewsAvailable character entries Character entry modesExtended 2 character table O Extended 1 character table NCyrillic character table P Initial settings TroubleshootingProblem Cause & solution Telephone Redial the number manually Specifications Index PINPage Page Page Customer Support Centre Tel. No 272 Sales Department Copyright