TG593xAL.book Page 40 Tuesday, April 11, 2006 10:31 AM
Answering System
Key | Remote command |
{*}{4} | Erase currently playing |
| message |
{*}{5} | Erase all messages |
|
|
*1 If pressed within the first 5 seconds of a message, the previous message is played.
*2 To resume operation, enter a remote command within 15 seconds, or the voice guidance starts.
Turning on the answering system remotely
If the answering system is off, you can turn it on remotely.
1 Dial your phone number.
2 Let the phone ring 15 times.
LThe unit answers your call with the greeting message.
LYou can hang up, or if you call from a touch tone phone, you can enter your remote code and begin remote operation (page 39).
Skipping the greeting message to leave a message
You can leave a message just as any outside caller can. Call your phone number. When the answering system picks up, press {*} to skip the greeting message and record your message after the beep.
Answering system settings
Remote code
A remote code must be entered when operating the answering system remotely. This code prevents unauthorised parties from listening to your messages remotely. The default setting is “11”.
1 {MENU} i{0}{6}{3}
2 Enter the desired
i{Save} i{OFF}
Ring count
You can change the number of times the phone rings before the unit answers calls. The default setting is “4”.
“Toll saver”: The unit answers on the 2nd ring when new messages have been recorded, and on the 4th ring when there are no new messages. If you call your phone from outside to listen to new messages (page 39), you will know that there are no new messages when the phone rings for the 3rd time. You can then hang up without being charged for the call.
1 {MENU} i{0}{6}{1}
2 Select the desired setting. i{Save}
i{OFF}
For Service Provider Voice Mail Subscribers
To receive Voice Mail and use answering system properly, please note the following:
40