Programming
Changing the handset name
Each handset can be given a customised name (“Bob”, “Kitchen”, etc.). This is useful when you make intercom calls between handsets. You can also select whether or not the handset name is displayed in standby mode. The default setting is “No”. If you select “Yes” without entering any handset name,
“Handset 1” to “Handset 6” is displayed.
1M
N (right soft key) #104
2Enter the desired name (max. 10 characters; page 33).
R If not required, go to step 3.
3MOKN
4MbN: Select the desired setting. a MOKN 2 times
5MeN
Incoming call barring (Caller ID subscribers only)
This feature allows the unit to reject calls from specified phone numbers that you do not want to answer such as junk calls.
When a call is received, the unit does not ring while the caller is being identified. If the phone number matches an entry in the call barred list, the unit emits no sound to the caller, and disconnects the call.
Important:
RWhen the unit receives a call from a number that is stored in the call barred list, the call is logged in the caller list
(page 29) with 
after the call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the call barred list.
Important:
RYou must store the phone number with an area code in the call barred list.
nFrom the caller list: 1 MCN (
)
2MbN: Select the entry to be barred. a M
N a M
N
3MbN: “Save CID” a MOKN
4MbN: “Caller Barred” a MOKN
5 MbN: “Yes” a MOKN a MeN
nBy entering phone numbers:
1 M
N (right soft key) #217 a
M
N
2Enter the phone number (24 digits max.). a MOKN
R To erase a digit, press MCN.
3MeN
Viewing/editing/erasing bar call numbers
1M
N (right soft key) #217
2MbN: Select the desired entry. R To exit, press MeN.
3To edit a number:
M
N a Edit the phone number. a MOKN a MeN
To erase a number:
M
N a MbN: “Yes” a MOKN a MeN
Note:
RWhen editing, press the desired dial key to add, MCN to erase.
Setting call restriction
You can restrict selected handsets from dialling certain numbers. You can assign up to 6 phone numbers to be restricted, and select which handsets are to be restricted. Storing area codes here prevents the restricted handsets from dialling any phone number in that area code.
1M
N (right soft key) #256
2Enter the base unit PIN (default: “0000”). R If you forget your PIN, contact an
authorised service centre.
3Select the handsets to be restricted by pressing 1 to 6.
R All handsets registered to the base unit are displayed.
26
2013/07/18 12:00:00