Panasonic KX-TG7851TU Registering a unit, Operating additional units, Additional handsets

Page 27
R “ ” is displayed next to the selected handset numbers.
R To cancel a selected handset, press the same dial key again. “ ” disappears.
4 MOKN
5 Select a memory location by pressing 1 to 6. a MOKN
6 Enter the phone number or area code to be restricted (8 digits max.). a MOKN a MeN
R To erase a restricted number, press MCN.
Changing the base unit PIN (Personal Identification Number)
Important:
R If you change the PIN, please make note of your new PIN. The unit will not reveal the PIN to you. If you forget your PIN, contact an authorised service centre.
1 M N (right soft key) #132
2 Enter the current 4-digit base unit PIN (default: 0000).
3 Enter the new 4-digit base unit PIN. a
MOKN

Programming

4MbN: Yesa MOKN a MeN

Registering a unit

Operating additional units

Additional handsets

Up to 6 handsets can be registered to the base unit.

Important:

RThe additional handset model recommended for use with this unit is noted on page 3. If another handset model is used, certain operations may not be available.

Registering a handset to the base unit

The supplied handset and base unit are pre-registered. If for some reason the handset is not registered to the base unit (for example, is displayed even when the handset is near the base unit), re-register the handset.

1Handset:

MN (right soft key) #130

2Base unit:

Press and hold MN for about 5 seconds. (No registration tone)

R If all registered handsets start ringing, press MN again to stop, then repeat this step.

R The next step must be completed within 90 seconds.

3Handset:

MOKN a Wait until Base PINis displayed. a Enter the base unit PIN (default: 0000). a MOKN

R If you forget your PIN, contact an authorised service centre.

R When the handset has been registered

successfully, is displayed.

Note:

R While registering, Base in registeringis displayed on all registered handsets.

RWhen you purchase an additional handset, refer to the additional handset’s installation manual for registration.

Deregistering a handset

A handset can cancel its own registration to the base unit, or other handsets registered to the same base unit. This allows the handset to end its wireless connection with the system.

1MN (right soft key) #131

R All handsets registered to the base unit are displayed.

2MbN: Select the handset you want to cancel. a MOKN

3MbN: Yesa MOKN

R A confirmation tone sounds.

27

TG7851TU(en-en)_0718_ver011.pdf 27

2013/07/18 12:00:00

Image 27
Contents Thank you for purchasing a Panasonic product Digital Cordless PhoneTable of Contents Expanding your phone system Accessory informationSupplied accessories Additional/replacement accessoriesDeclaration of Conformity General informationFor your safety Base unit location/avoiding noise Important safety instructionsBattery For best performanceFor business users in the European Union SpecificationsOther information Routine careRF transmission power Frequency rangeOperating conditions Base unit Setting upBattery installation ConnectionsIcon Battery level Battery chargingDuring a power failure Battery levelControls HandsetBase unit Handset main menu icons DisplayHandset display items Handset soft key iconsScreen saver mode Turning the power on/offInitial settings One touch eco mode Display modeProgramming the display mode beforehand Answering calls Making callsUseful features during a call MbN Equalizer a Mokn Key lockHandset equalizer Call shareShared phonebook MbN Phonebook a Mokn Speed dial Display the menu tree and direct command code table Programmable settingsTime Settings Set Date/Time*1 Ringer Setup Ringer VolumeNight Mode Start/End Night Mode 30 secRepeater Mode *1 Line SetupDial Mode *1 Pulse Msec # 160 msec Privacy Mode *1, *10Operation Code Storing/Viewing bar call numbers #217 AlarmSpecial programming #173 Off Main menuChanging the start and end time Night modeTurning night mode on/off Setting the ring delayStoring unwanted callers Setting call restrictionChanging the handset name Incoming call barring Caller ID subscribers onlyAdditional handsets Registering a unitOperating additional units Registering a handset to the base unitSetting the repeater mode Increasing the range of the base unitDect repeater Viewing the caller list and calling back Using Caller ID serviceCaller ID features Caller listErasing selected caller information Erasing all caller informationStoring caller information to the phonebook Voice mail service Intercom Handset locatorTransferring calls, conference calls Character entry modes Character entryExtended 1 character table Extended 2 character tableCyrillic character table Error messages Cause/solutionDisplay message General use TroubleshootingProgrammable settings ProblemMaking/answering calls, intercom Battery rechargeLiquid damage Caller IDIndex TU-1/2 For your future referenceAttach your purchase receipt here