Panasonic KX-TG7851TU Increasing the range of the base unit, Setting the repeater mode

Page 28

Programming

RThe handset does not beep when cancelling its own registration.

4MeN

Increasing the range of the base unit

You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 3. Contact your Panasonic dealer for details.

Important:

RBefore registering the repeater to this base unit, you must turn the repeater mode on.

RDo not use more than one repeater at a time.

Setting the repeater mode

1MN (right soft key) #138

2MbN: Select the desired setting. a MOKN a MeN

Note:

RAfter turning the repeater mode on or off,

may be displayed on the handset momentarily. This is normal and the

handset can be used once is displayed.

Registering the DECT repeater (KX-A405) to the base unit

Note:

RPlease use a repeater that has not yet been registered to another unit. If the repeater is registered to another unit, deregister it first, referring to the Installation Guide for the DECT repeater.

1Base unit:

Press and hold MN for about 5 seconds. (No registration tone)

R The next step must be completed within 90 seconds.

2DECT repeater:

Connect the AC adaptor, then wait until

the indicator and indicator light green.

3Base unit:

To exit the registration mode, press MN.

28

TG7851TU(en-en)_0718_ver011.pdf 28

2013/07/18 12:00:00

Image 28

Contents Digital Cordless Phone Thank you for purchasing a Panasonic productTable of Contents Accessory information Supplied accessoriesAdditional/replacement accessories Expanding your phone systemGeneral information Declaration of ConformityFor your safety Important safety instructions BatteryFor best performance Base unit location/avoiding noiseSpecifications Other informationRoutine care For business users in the European UnionFrequency range RF transmission powerOperating conditions Setting up Battery installationConnections Base unitBattery charging During a power failureBattery level Icon Battery levelHandset ControlsBase unit Display Handset display itemsHandset soft key icons Handset main menu iconsTurning the power on/off Screen saver modeInitial settings Display mode One touch eco modeProgramming the display mode beforehand Making calls Answering callsUseful features during a call Key lock Handset equalizerCall share MbN Equalizer a MoknShared phonebook MbN Phonebook a Mokn Speed dial Programmable settings Display the menu tree and direct command code tableRinger Setup Ringer Volume Night ModeStart/End Night Mode 30 sec Time Settings Set Date/Time*1Line Setup Dial Mode *1 PulseMsec # 160 msec Privacy Mode *1, *10 Repeater Mode *1Alarm Special programming#173 Off Main menu Operation Code Storing/Viewing bar call numbers #217Night mode Turning night mode on/offSetting the ring delay Changing the start and end timeSetting call restriction Changing the handset nameIncoming call barring Caller ID subscribers only Storing unwanted callersRegistering a unit Operating additional unitsRegistering a handset to the base unit Additional handsetsIncreasing the range of the base unit Setting the repeater modeDect repeater Using Caller ID service Caller ID featuresCaller list Viewing the caller list and calling backErasing all caller information Erasing selected caller informationStoring caller information to the phonebook Voice mail service Handset locator IntercomTransferring calls, conference calls Character entry Character entry modesExtended 2 character table Extended 1 character tableCyrillic character table Cause/solution Error messagesDisplay message Troubleshooting Programmable settingsProblem General useBattery recharge Making/answering calls, intercomCaller ID Liquid damageIndex For your future reference TU-1/2Attach your purchase receipt here