Panasonic TG2382PW operating instructions FCC and Other Information

Page 74

FCC and Other Information

Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR. This will often reduce, or eliminate, interference.

Operating near 2.4GHz electrical appliances may cause interference. Move away from the electrical appliances.

CAUTION:

To comply with FCC RF exposure requirements, the base unit should be installed with its antenna located at 20 cm or more from persons and handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-clips or similar body-worn accessories may not comply, therefore, should be avoided.

This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68.316.

When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some Hearing Aids are not adequately shielded from external RF (radio frequency) energy. If noise occurs, use an optional headset accessory or the speakerphone option (if applicable) when using this phone. Consult with your audiologist or Hearing Aid manufacturer about the availability of Hearing Aids which provide adequate shielding to RF energy commonly emitted by digital devices.

•Environment — do not place the unit in a room where the temperature is less than 5°C (41°F) or greater than 40°C (104°F). Allow 10 cm (4") clearance around the unit for proper ventilation. Avoid excessive smoke, dust, mechanical vibration, shock, or direct sunlight.

•Medical — consult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to determine if they are adequately shielded from external RF (radio frequency) energy. (The unit operates in the frequency range of 2400MHz to 2480MHz, and the power output level can range 0.04 watts to 0.40 watts.) Do not use the unit in health care facilities if any regulations posted in the area instruct you not to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF (radio frequency) energy.

•Routine care — wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder. When you leave the unit unused for a long period of time, unplug the AC adaptor from the outlet.

•If there is any trouble — disconnect the unit from the telephone line and connect a known working phone. If the known working phone operates properly, have your unit repaired by a Factory Servicenter or other Authorized Servicer. If the known working phone does not operate properly, consult your telephone company.

74

Page 73 Page 75
Image 74
Page 73 Page 75
Contents Charge the battery for about 15 hours before initial use Operating InstructionsFor extra orders, call Accessories includedAttach your purchase receipt here Energy Star For KX-TG2382B/KX-TG2382PW users For KX-TG2383S usersContents Temporary Tone Dialing For Rotary or Pulse Service Users Canceling the Handset RegistrationBase unit location/Noise Battery chargeFor Best Performance Charger unit Location of ControlsBase unit Handset How to use the Navigator keyLocation of Controls This key has four active areas that are indicated by arrowsInstallation ConnectionsInstallation Installing the Battery in the HandsetBattery Charge ChargingDisplay prompt Battery strength Battery strengthBattery information RechargeBelt Clip Connecting the optional headset to the handsetTo switch to the speakerphone while using the headset Optional HeadsetProgramming Guidelines Programmable SettingsHow to select a function item from the menu Ringer tone GF H=SaveUseful information Programmable SettingsFunction Menu Table Press Ö Next key Date and TimeScroll to Date and time by pressing Ö or Ñ Press á Press á Save keyTo check the date/time Dialing ModeFor Caller ID service users p Line Mode Select a or B by pressing Ö or Ñ Press á Save keyAuto Talk Feature Select On or Off by pressing Ö or Ñ Press á Save keySelect the desired volume by pressing Ö or Ñ Ringer VolumeScroll to Ringer setting by pressing Ö or Ñ, and press á To turn the ringer onLCD contrast LCD ContrastDate and time HInitial set Hlcd contrast Auto talk LCD contrast Low HighPreparing the Answering System Press GREETING!REC to start the recording modeWhen finished, press Greeting MessageTo check the recorded greeting message Flash Memory Message Backup Message storagePreparing the Answering System To erase the recorded greeting messageIf you select Greeting only, the unit will answer a Caller’s Recording TimeSelect the recording time by pressing Ö or Number of Rings Toll saverUsing the Handset Making CallsHands-free Digital Duplex Speakerphone Making CallsPress Dial a phone number For best performance, please note the followingTo redial the last number dialed on the handset To redial using the redial list Memory RedialTo dial after confirming the entered number Lighted handset keypad To put a call on holdTo release the hold Backlit LCD displayPressing Answering CallsAuto Talk Caller ID Service How caller information is displayed when a call is receivedUsing the Caller List Viewing the Caller ListWhat √ means Using the Caller ListCalling Back from the Caller List If a caller calls more than onceScroll to the desired caller by pressing Or Ñ Press á Caller ID Number Auto Edit Feature pEditing the Caller’s Phone Number Auto talk HCaller ID edit Set tel line Caller ID Number Auto Edit FeatureScroll to Caller ID edit by pressing Ö or Ñ, and press á Auto edit GF H=SaveCaller list 10 new calls GF H=Directory Storing Caller List Information in the DirectoryScroll to Save directory by pressing Ö or Ñ, and press á Edit HSave directoryTo erase all entries in the Caller List Erasing Caller List InformationTo erase a specific caller from the Caller List ClearPress Ö Next key Enter a phone number, up to 22 digits DirectoryStoring Names and Numbers For example, to enter Tom Jones DirectorySelecting characters to enter names To search for a name by initial Dialing from the DirectoryIf you make a mistake while entering a name Index table4567890 IH G=Next 12344567890 EditingPress Ö Next key Add a number to the current number Jane WalkerErasing Helen Clear? =No CLEAR=YesTo page the base unit, press IntercomMaking Intercom Calls To page another handsetDuring an intercom call Answering Intercom CallsTo page all handsets, press Handset LOCATOR/INTERCOM ALL Auto TalkTransferring a Call To transfer a call from the handsetEx. a conference call with Handset 1 Conference CallsCall Share To join a conversation Call ShareTemporary Tone Dialing Special FeaturesFor Call Waiting Service Users Muting Your ConversationFor PBX Line/Long Distance Calls How to Use the Pause ButtonFlash Button Selecting the flash timeIncoming Call Tone Special FeaturesRinger Tone Select the desired ringer tone by pressingMonitoring incoming calls Setting the Unit to Answer CallsAutomatic Answering Operation Press ANSWER!ON to turn on the Answering SystemListening to Messages To play back messagesErasing a specific message Erasing MessagesDuring playback Erasing all messagesVoice menu Remote Operation with the HandsetTo listen to messages Scroll to Message play by pressing Ö orDirect commands ALL Message PlaybackRemote Operation from a Touch Tone Phone Summary of remote operationTo check the remote code Enter a remote code using a 2-digit number Press á Save keyRemote Code Remote code 11 H=Save 35 H=SaveShaded parts are voice prompts Voice MenuRemote Operation from a Touch Tone Phone Skipping the greeting message Direct Remote OperationTurning on the Answering System Call your unit and wait for 15 ringsWall Mounting To charge the handset battery Adding Another Phone Wall MountingBattery Replacement Scroll to Deregistration by pressing Ö or Ñ Canceling the Handset RegistrationDate and time HInitial set Set answering HHS register Registration HDeregistrationHandset Re-registering the HandsetBase unit If the Following Appear Directory memory is full. To erase other items When trying to store an item in the directory,Base unit. To cancel another handset From the directory, seeTroubleshooting Cordless Telephone ProblemConference call, you cannot Problem Cause & RemedyTo page. Try again later Handset or the base unit. Try again laterTroubleshooting Answering System Problem Cause & RemedyGeneral Problem Currently registered to another base unit Battery has been discharged. Charge the battery fully pClean the charge contacts and charge again For KX-TG2382B/KX-TG2382PWImportant Safety Instructions Important Safety Instructions FCC and Other InformationUseful Information FCC and Other Information Battery Charge IndexSpecifications IndexPanasonic Telephone Products Limited Warranty Limited Warranty CoverageCustomer Services Directory For your future reference For product serviceWhen you ship the product Serial No Date of purchase
Top Page Image Contents