Wall Mounting

1.Remove the wall mounting adaptor from the unit as shown, set the operation board to level 1, then connect and secure the cables.

•The cables can also be run from the top of the unit (page 14, 15).

2.Attach the wall mounting adaptor as shown.

•Make sure the cables are not pinched by the wall mounting adaptor. When running the cables from the top of the unit, look through the opening in the wall mounting adaptor (A) to confirm that the cables are not being pinched.

Slide the wall mounting adaptor up to this point.

3.Drive the 2 screws (included) into the wall either 83 mm or 100 mm apart, and mount the unit on the wall.

•You can find a wall mounting template on page 23.

•Make sure that the wall that the unit will be attached to is strong enough to support the unit (approx. 1.5 kg; approx. 2.5 kg when the KX-NT305 is attached).

•Make sure the cables are securely fastened to the wall.

•When this product is no longer in use, make sure to detach it from the wall.

83 mm

100 mm

Washer

Drive the screw to this point.

•If using a KX-NT305, attach the KX-NT305 (page 17) to the unit first, and perform step 3 only.

•For information on locking the handset hook, refer to page 13.