Using the Unit
{PUSH} mode (Push to talk mode)
1
2
When a ringer tone is heard, press {TALK}.
Speak to the visitor.
3 To end the conversation, press {TALK}. LThe display will turn off.
{AUTO} mode (Auto talk mode)
This mode allows you to answer the call by voice. Speak a brief reply into (or toward) the monitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; the visitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode has started and you may then speak to the visitor.
1
2
3
When a ringer tone is heard, answer “Yes?” within 30 seconds.
LA beep will sound to indicate that you can talk to the visitor
Speak to the visitor.
To end the conversation, press {TALK}.
Note:
LMake sure you are within about 50 cm of the monitor station. LYou can also answer the call by pressing {TALK}.
LYour initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.
LIf a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} mode even though you have not replied by voice.
{HOLD} mode (Hold to talk mode)
1
2
3
4
When a ringer tone is heard, press and hold {TALK} to speak to the caller. LA beep will sound and the Talking indicator will light.
To listen to the visitor, release {TALK}.
LThe Talking indicator will turn off.
To speak again, press and hold {TALK}.
To end the conversation, tap {TALK}.
Note:
LMake sure you speak to the caller only while pressing {TALK} and release {TALK} when you have stopped speaking so that the caller can speak to you.
32