Cisco Systems ATA 186 manual ReorderTone Parameter Example1, Component Setting Explanation

Chapter 5 Parameters and Defaults

Tone Configuration Parameters

•TotalToneTime is the total length of time that the tone plays. If this value is 0, the tone will play until another call event stops the tone.

This value is in 10 ms units (100 ms = 1 second).

Two examples of Extended Format B, both using the Reorder tone, follow.

ReorderTone Parameter Example1

Assume that you want a reorder tone in which:

•The frequencies 900 Hz, 1400 Hz, and 1800 Hz play sequentially.

•Each frequency plays once for 0.33 seconds.

•There is no silence after the first and the second frequencies.

•There is 1 second of silence after the third frequency (before the first frequency starts again)

•The volume of each frequency is –19 dBm.

•The tone plays until another call event stops the tone.

For this reorder tone, make the following setting. See Table 5-5for a detailed explanation.

ReorderTone:101,3,24917,3405,14876,4671,5126,5178,3,2640,0,2640,0,

2640,8000,0,0

Table 5-5 Reorder Tone Parameter Example 1 Explanation

Component	Setting	Explanation
Sequential	101	Frequencies play sequentially
NumOfFreqs	3	Three frequencies in the tone
TFreq1	24917	First frequency is 900 Hz
TAmpl1	3405	First frequency volume is –19 dBm
TFreq2	14876	Second frequency is 1400 Hz
TAmp2	4671	Second frequency volume is –19 dBm
TFreq3	5126	Third frequency is 1800 Hz
TAmp3	5178	Third frequency volume is –19 dBm
NumOfOnOffPairs	3	Three on-off pairs in the cadence of the tone
OnTime1	2640	Sound in first on-off pair plays for 0.33
		seconds
OffTime	0	No silence after the first sound (the second
		sound plays immediately)
OnTime2	2640	Sound in second on-off pair plays for 0.33
		seconds
OffTime2	0	No silence after the second sound (the third
		sound plays immediately)
OnTime3	2640	Sound in third on-off pair plays for 0.33
		seconds
OffTime3	8000	1 second of silence after the sound in the third
		on-off pair (before the pattern repeats,
		beginning with the first on-off pair)

Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for MGCP (version 3.0)

5-34 OL-4803-01