Feed Rollers
The infeed and outfeed rollers and chipbreaker have been factory set. However, if spring tension adjustment should ever be necessary, use the appropriate adjustment assembly located beneath the lip of the frame – one is shown in Figure 13.
1.Loosen the nut and turn the screw in or out. When finished, tighten nut.
2.Perform the same adjustment at the opposite end of the roller.
Figure 13
Table Rollers
The table rollers can be raised or lowered with the handle (Figure 14). A label is affixed near the handle for reference.
Maintenance
Figure 14
Before any intervention on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch! Follow lockout/tagout procedures. Failure to comply may cause serious injury.
The
The table should be kept clean and free of rust or deposits.
The lead screws and posts beneath the table, and the drive chains, should be kept clean and oiled.
Periodically blow out saw dust from the motor’s cooling fan.
14