Powermatic WP2412 operating instructions

Page 5

20.Make your workshop child proof with padlocks, master switches or by removing starter keys.

21.Give your work undivided attention. Looking around, carrying on a conversation and “horse-play” are careless acts that can result in serious injury.

22.Maintain a balanced stance at all times so that you do not fall or lean against the knives or other moving parts. Do not overreach or use excessive force to perform any machine operation.

23.Use the right tool at the correct speed and feed rate. Do not force a tool or attachment to do a job for which it was not designed. The right tool will do the job better and safer.

24.Use recommended accessories; improper accessories may be hazardous.

25.Maintain tools with care. Keep knives sharp and clean for the best and safest performance. Follow instructions for lubricating and changing accessories.

26.Turn off the machine before cleaning. Use a brush or compressed air to remove chips or debris — do not use your hands.

27.Do not stand on the machine. Serious injury could occur if the machine tips over.

28.Never leave the machine running unattended. Turn the power off and do not leave the machine until it comes to a complete stop.

29.Remove loose items and unnecessary work pieces from the area before starting the machine.

Familiarize yourself with the following safety notices used in this manual:

This means that if precautions are not heeded, it may result in minor injury and/or possible machine damage.

This means that if precautions are not heeded, it may result in serious injury or possibly even death.

- - SAVE THESE INSTRUCTIONS - -

5

Image 5
Contents Part No. M-0460285 Inch Wood PlanerMore Information WMH Tool Group Warranty Warranty and ServiceTable of Contents Page Page Introduction Description SpecificationsWP2412 Planer Dimensions Unpacking Contents of the Shipping ContainerElectrical Connections InstallationTools required for installation Starting procedure AdjustmentsDust Collection ControlsCalibrating Digital Display Do not loosen any screws on the cutterhead Changing FusesChanging Knives Drive Chain Replacement Belt Tension & ReplacementTable Rollers MaintenanceFeed Rollers Probable Cause Remedy Troubleshooting Operating ProblemsTrouble Troubleshooting Mechanical & Electrical Problems If you have access to a voltmeter, you Replacement Parts Index No. Part No Description Size Parts List Drawing NoIndex No. Part No Description Drawing No TS-1541041 Drawing No WP2412-301 Main Bearing Housing, Left BB6209V Drawing No WP2412-401 Hood Handle WP2412-121 Drawing No WP2412-501 Main Motor 15HP, 230V, 3Ph WP2412-502 Drawing No Parts List Electrical Box Electrical Box Parts List Control Panel Electrical Connections 230 Volt Electrical Connections 230 Volt Page WMH Tool Group