PRIORITY SCAN CHANNEL
To set a priority scan channel:
1.Press select/ 
momentarily four times while in standby mode to enter Priority Scan Channel mode. The current priority channel will be
indicated.
2. Press 
or key to increase or decrease the desired channel number.
3.Press select/ 
three times to confirm and exit to standby mode. PRI will be displayed when a priority channel has been selected.
BCL (Busy Channel Lockout) ON/OFF
BCL is used when CTCSS or DCS is selected to prevent transmission when the uh064sx detects a transmission from another unit using the same CTCSS or DCS code.
To set BCL ON/OFF:
1.Press select/ 
momentarily five times while in standby mode to enter BCL ON/OFF mode.
The current BCL status will be indicated.
2. Press | or | key to select ON (on) or OFF (oF). |
3.Press select/ 
two times to confirm and exit to standby mode. BCL will be displayed when BCL on has been selected.
SCAN CHANNEL MEMORY
To store a channel into Scan Channel Memory:
1. Select desired channel using ch/txp key and | or | key. |
2.Press and hold mem/SCN key. MEM will appear on the display.
Repeat steps 1 and 2 to clear channel from Scan Channel Memory.
(11)