Uniden UH044SX manual Example. CH40 becomes active

Page 16

UNIDEN Model uh044sx UHF CB Radio

OPERATION

OPEN SCAN (OS) Mode (the absence of GS icon indicates that the unit is on OS mode)

Allows continuous scanning of channels stored in the Open Scan (OS) memory.

If an active channel is found, scanning will stop on that channel.

The factory has preprogrammed all the 40 UHF channels into the Open Scan channel memory. However, you can change or customise the channels by following the steps on programming Scan Channels on page 17.

Example. CH40 becomes active

If the received signal cease, the unit will wait for at least 3 seconds for the signal to return, otherwise scanning resumes.

To skip the active channel, press or . Scanning resumes.

To deactivate SCAN, press the or .

1.If SCAN is deactivated while in an active channel, the uh044sx will stay on that active channel. If no other channels are active, the uh044sx will reinstate the starting channel.

2.If OS Scanning is initiated when there are no channels programmed in OS memory, an error tone will be heard and scanning will not start.

15

Image 16
Contents UH044SX Uniden Model uh044sx UHF CB Radio Contents Features IntroductionControls & Indicators Controls & Indicators Optional Accessories Included in Your UH044SX PackBattery Installation Getting StartedCharging Batteries Battery Level Display LOW Battery Alert Power ON/OFF VolumeSetting the Squelch OperationSelecting a Channel To Transmit and ReceiveTo Operate in Duplex Mode Repeaters You can only activate Duplex on CH01-CH08Transmit Power Select ScanningExample. CH40 becomes active Group Scangs Mode Priority Channel Dual Watch MonitorCtcss VOX Call Tone Busy Channel Lockout KEY BeepKeypad Lock Power SaveBack Lighting UHF CB Channels & Frequencies Please follow these guidelines for channel use in AustraliaCtcss & DCS Code List Warranty Uniden UH044SX UHF CB Transceiver RadioUniden Australia Pty Limited/Uniden New Zealand Limited