Wallinstallation

Your DS70 can be fitted with a Desk Stand or mounted on the wall.

Beforeconnectingyour phoneline,fully chargethe Nickel-MetalHydridebattery packfor 15-20hours.

Thread both the telephone line cord and the power cord through the semi-circle hole in the back of the Desk Stand.

Insert the two tabs, located on the base of the Desk Stand, into the slots on the bottom of the Base Unit.

Push down gently until the tab locks into the top of the Base Unit.

Now connect the telephone line cord and AC power cord into the Base Unit as

shown on page 8.

Placethepowercordso thatit doesnot createa trip hazardor whereit could becomechafedandcreatea fire or electricalhazard.

Use only the Uniden AC

adaptor supplied with this

phone. Make sure it is switched ON at all times.

3, pushthedesk

stand down gently untilthe tab locks

intothe top of the base unit

1.telephone line & power

cords threaded through the desk stand,

Your DS70 can be wall mounted on a standard telephone wall plate.

. Do not install the desk stand.

. Now connect the telephone line cord and AC power cord into the Base Unit as

shown on page 8.

. Position the Base so the mounting studs on the standard telephone wall plate fit into the holes on the back of the Base Unit.

. Slide the Base down on the mounting studs until it locks into place.