BASIC OPERATION
RECORDING A MEMO
OPERATION | A memo is a message you can record by speaking directly into the | ||
| |||
| DTAM, without having to call in on the phone. | ||
BASIC | Follow these steps to record a memo up to 60 seconds long. | ||
1. Press memo until | appears. | ||
| |||
The DTAM sounds a long beep and appears. Speak into the
microphone in a normal voice. The display counts up the recording time.
2. The DTAM automatically stops recording after 60 seconds or
after 8 seconds of silence, or you can press 
button when you finish the memo. The DTAM beeps once, and the message number indicator increases by one.
The memo is stored along with the incoming messages. To hear the memo, simply play back your messages.
USING CALL BREAKTHROUGH
If you screen your calls but want to be sure to know when calls come in from certain people, give those people your call breakthrough (CBT) code. Tell them to enter the code during the outgoing message.
BASIC OPERATION
When a caller enters the CBT code, the DTAM alerts you with loud | BASIC | ||||||||||||
beeps for 35 seconds. Then the DTAM sounds two beeps every two | |||||||||||||
seconds for 30 seconds, and one short beep every second for the | |||||||||||||
| |||||||||||||
last 5 seconds. To answer the call, pick up the handset. If you | OPERATION | ||||||||||||
do not answer, the caller can leave a message after the outgoing | |||||||||||||
| |||||||||||||
message plays and a long beep sounds. |
|
|
| ||||||||||
CHANGING THE CBT CODE |
|
|
| ||||||||||
The CBT code is preset to 648, but you can change it by following |
| ||||||||||||
these steps: |
|
|
|
|
|
|
| ||||||
1. Hold down | code set | until the DTAM beeps once | appears. |
| |||||||||
NOTE: | Be sure to set each digit within 8 seconds. Otherwise, you must start |
| |||||||||||
|
|
|
|
| over from Step 1. |
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
| |
2. Press |
| The DTAM beeps and | appears followed by the |
| |||||||||
| digits of the preset CBT code in sequence, then the first digit |
| |||||||||||
| reappears. For | example, when the security code is 648, the |
| ||||||||||
| display shows |
| , | , , then | reappears. |
|
| ||||||
3.Repeatedly press 
or 
to set the first digit, then press 
. The second digit appears.
4.Press 
or 
to set the second digit, then press 
The third digit appears.
5.Press 
or 
to set the third digit, then press 
. The DTAM sounds a long beep and announces the CBT code.
30 | 31 |