Uniden 7100A Basic Operation, Recording Incoming Messages, Screening Calls, Adjusting the Volume

Page 14

BASIC OPERATION

RECORDING INCOMING MESSAGES

OPERATION

The maximum incoming message recording length is 60 seconds.

 

 

When a recording reaches 55 seconds, the DTAM beeps once to

 

notify the caller that time will soon be up. When the recording

BASIC

reaches 60 seconds, the DTAM sounds one long and four short

beeps, and plays "Thank you for your call", then hangs up.

 

The DTAM hangs up and resets to answer the next call when:

The caller hangs up.

The maximum message length (60 seconds) is reached.

There are more than 8 seconds of silence.

If the DTAM’s memory is full (appears), it will answer the call after 3 rings then play the announcement only message (OGM2).

If no OGM2 is recorded, the DTAM announces "Memory is full, thank you for your call". Please delete some messages to restore normal operation.

SCREENING CALLS

To screen calls, let the DTAM answer them, then listen to the caller’s message through the DTAM’ speaker. If you decide to

answer the call, pick up the phone and press on the DTAM.

If you do not want to take the call, do not pick up the phone, and let the DTAM finish recording the caller’s message.

BASIC OPERATION

ADJUSTING THE VOLUME

Adjust volume slider, on the right side of the DTAM to the desired listening level.

PLAYING MESSAGES

The display shows the total number of messages. If there are new messages, the message light also flashes until all new messages have been played.

To play all the messages (old and new), press . The DTAM announces the number of messages recorded, each

message number and the day and time the message was recorded and then plays the message.

PLAYING NEW MESSAGES ONLY To play only new messages, hold

down for 2 seconds.

(If there are no new messages stored, the DTAM says "You have no new messages").

Adjust the volume to your desired listening level. After all messages have played, the DTAM says, "End of message(s)" and saves all the messages.

BASIC OPERATION

26

27

Image 14
Contents 7100A Contents Screening Calls Safety InformationRead this Before Installation Reliability, long life and outstanding performance Safety InformationIntroduction 7100A has a generous 18 minute memory capacity7100A Dtam AC AdaptorFeatures Your DTAM’S Features IncludeFeatures FunctionsSelecting a Location InstallationFunctions Backup Battery InstallationConnecting Power Hold down time set . clock Displays briefly then Setting the DAY and TimePreparation Recording the Outgoing Messages PreparationRecording the Outgoing Messages Warranty Preparation Setting the Number of RingsTo Turn The Dtam On Setting the Dtam to Answer CallsBasic Operation Recording Incoming Messages Adjusting the VolumeBasic Operation Screening CallsPause Message Playback BasicTo replay a message while you are listening to it, press Fast PlaybackChanging the CBT Code Using Call BreakthroughRecording a Memo ThenCall your telephone Remote OperationRemote Operation Remote Answer-onUsing Remote Commands Remote OperationTroubleshooting Problem SuggestionTroubleshooting Care and MaintenanceWarranty Uniden 7100A 1 Year Warranty