Setting and Adjusting the
Projector (Settings & Adjustments)
Example:“Picture”screen display for COMPUTER
On these screens, you can make projector settings or adjustments.You can set or adjust the following items :
• Picture Mode | • Setup Guide |
• CLR Temp | • Projection Mode |
• BrilliantColorTM | • OSD Language |
• Progressive | • Auto Sync |
• DNR | • Auto Power Off |
• Lamp Setting | • Auto Restart |
• Resolution Setting | • System Sound |
• Signal Type | • Internal Speaker |
• Video System | • Audio Input |
• Dynamic Range | • |
• Resize | • Fan Mode |
• OSD Display | • All Reset |
• Background |
|
Note
•If you click the “Refresh” button before the screen is displayed completely, an error message (“Server Busy Error”) will be dis- played. Wait for a moment and then oper- ate again.
•You cannot operate this page while the pro- jector is warming up.
•For details about each item, refer to the projector’s operation manual.
Controlling the Projector via LAN
Setting the Security
(Network – Security)
On this screen, you can make settings relat- ing to security.
| Items | Description |
User Name | Setting of user name for | |
|
| security protection. |
|
|
|
Password | Setting of password for | |
|
| security protection. |
Accept IP | It is possible to set up to three | |
Address | IP addresses allowing connec- | |
|
| tion to the projector. |
| All IP | No limits are set to IP addresses |
| Addresses | connecting to the projector. |
| From only | For security improvement, only an |
| specific IP | IP address set by “Address |
| addresses | can be connected to the projector. |
Note
•User Name and Password can be up to 8 characters.
•You can input the characters below :
-17
