Sharp PG-F325W Disconnecting All Connec, Setting Auto Logout Time, Entering ADVANCED SETUP MENU

Setting up the Projector Using RS-232C or Telnet

Disconnecting All Connec-

tions ([D]Disconnect All)

Setting Auto Logout Time

(ADVANCED[1]Auto Logout Time)

It is possible to disconnect all the TCP/IP connec- tions currently recognized by the projector. Even if the COM Redirect port is fixed in the Busy status due to a problem, it is possible to force the Ready status back by carrying out this disconnection.

setup>d	1
Disconnect All Connections(y/n)?y	2
Now Disconnecting...

1Enter “d” and press the “Enter” key.

2 Enter “y” and press the “Enter” key.

Note

•If Disconnect All is performed, the connection to the projector via network will be forcibly discon- nected.

Entering ADVANCED SETUP MENU

([A]Advanced Setup)

Enters ADVANCED SETUP MENU.

setup>a	1
******************** ADVANCED SETUP MENU ***********************
[1]Auto Logout Time	[2]Data Port
[5]Network Ping Test
[6]Accept IP Addr(1)	[7]Accept IP Addr(2) [8]Accept IP Addr(3)
[9]Accept All IP Addr	[0]Search Port

[!]Restore Default Setting [Q]Return to Main Menu

advanced>

1 Enter “a” and press the “Enter” key.

If there is no input after a fixed time, the projector automatically disconnects network connection using the Auto Logout function. It is possible to set the time until the projector is automatically disconnected in units of a minute (from 1 to 65535 minutes).

advanced>1		1
Valid range	: 0 to 65535 (minute)
note: if you enter “0”, auto logout function will be disable.
Auto Logout Time : 5
Please Enter	:15		2
(change)	—> 15	*

1Enter “1” and press the “Enter” key.

2Enter numerical value and press the“Enter”key. Display set numerical value (*).

Note

•If the set value is made 0, the Auto Logout func- tion is disabled.

•If an invalid number is entered, an error message (“Parameter Error!”) will be displayed and the screen returns to the ADVANCED SETUP MENU.

Data Port Setting

(ADVANCED[2]Data Port)

Setting of TCP port number. It is possible to set in the range of 1025 to 65535.

advanced>2		1
Valid range	:1025 to 65535
Data Port	:10002
Please Enter	:10005		2
(change)	—> 10005	*

1Enter “2” and press the “Enter” key.

2Enter numerical value and press the“Enter”key. Display set numerical value (*).

Note

•Set according to need. Normally, use with the fac- tory default setting.

-27