REMOTE OPERATION
OPERATION | 6 | Stop playback and message recording. | |
|
| ||
7 | When you finish, press 6. The DTAM beeps and replays. | ||
| Record a memo. | ||
| 81 | Change OGM1. After the DTAM beeps, begin your new OGM1. | |
REMOTE |
|
| |
82 | Play OGM1. If no OGM1 is recorded, the DTAM announces "You | ||
| |||
|
| have no announcement one". | |
|
|
| |
| 91 | Change OGM2. After the DTAM beeps, begin your new OGM2. | |
|
| When you finish, press 6. The DTAM beeps and replays. | |
|
|
| |
| 92 | Play OGM2. If no OGM2 is recorded, the DTAM announces "You | |
|
| have no announcement two". | |
|
|
|
After you press 2 or 3 to play messages:
Press | To |
1 | Replay the previous message |
3Skip to the next message
4Replay the current message
5Delete the current message
6Stop message playback
TROUBLESHOOTING
IF your 7100A DTAM unit is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service for assistance.
PROBLEM | SUGGESTION |
Answering system does not work | • Make sure the telephone line cord |
| is plugged in. |
| • Make sure that the AC Adaptor |
| is plugged in. |
| • Make sure the DTAM is turned on. |
| • There has been a power failure. |
| Disconnect the telephone line cord, |
| press the reset button and |
| the telephone line cord. |
|
|
Answering System does not answers | • The memory may be full. Delete some |
after 3 rings. | or all of the saved messages. |
|
|
Messages are incomplete. | • The incoming messages may be too long. |
| • The memory may be full. Delete some |
| or all of the saved messages. |
|
|
No sound on the base unit speaker during | • Adjust the volume control on the side of |
call monitoring or message playback. | the DTAM. Refer page 26 |
|
|
Cannot record outgoing message (OGM) | • The memory may be full. Delete some or |
| all of the saved messages. |
|
|
| Continued over.... |
TROUBLESHOOTING
36 | 37 |