Quick Reference
p@ @c@Hlcd@r @oI
STEP 1: Enter remote programming mode by holding down buttons (II + III) for 2.5 seconds. The remote will beep once and the LCD will read “Prog” to indicate that you have successfully entered programming mode.
STEP 2: After entering programming mode. Adjust the time settings by tapping button (I) to change the hour and tapping button (II) to adjust the minutes.
STEP 3: Once the desired time has been set, exit remote programming by holding down buttons (II + III) for 2.5 seconds. The remote will beep three times indicating that you have successfully exited programming mode.
Quick Reference
Rw@r @b@f
| Button | Duration | AdditionalProgramming | Function / Description |
|
|
| Required |
|
| I | 0.5 seconds | no | Locks doors and/or arms alarm. Tap again to unlock door and/or disarm alarm. |
|
| 2.5 seconds | Option | Run time extender. Resets remote start and turbo run time while vehicle is remote started |
|
|
|
|
|
| II | 0.5 seconds | no | Aux 1. Triggers the auxiliary 1 output (most commonly used for rear defrost or window |
| 2.5 seconds | no | Activates the remote start. Repeat and remote start will shut off | |
|
| |||
| III | 0.5 seconds | no | Aux 2. Triggers the auxiliary 2 output (most commonly used for rear defrost or window |
|
|
|
| |
| 2.5 seconds | no | Trunk pop. Triggers the trunk release output and opens the vehicle’s trunk. | |
|
| |||
|
|
|
|
|
| IV | 0.5 seconds | no | CarCheck(updatesvehiclestatusonremotepager)/SecureAuxiliary/TemperatureDisplay/VehicleVoltageDisplay |
| 2.5 seconds | no | Panic/vehicle locator (flashes vehicle’s parking lights and sounds siren and horn) | |
|
| |||
| I + II | 0.5 seconds | no | Turnssirenchirpson/off(Note:Withthesirenchirpsoff,itwillstillsoundintheeventthealarmis triggered) |
|
|
|
| |
| 2.5 seconds | no | Option programming menu 1. For use during installation. | |
|
| |||
|
|
|
|
|
| I + III | 0.5 seconds | no | Valet mode (see page 5 for details) |
| 2.5 seconds | no | Turns the shock sensor on/off. (Alarm or Alarm/Starter systems only) | |
|
| |||
| I + IV | 0.5 seconds | Option | Drive lock. Activates ignition controlled door locks. |
|
|
|
| |
| 2.5 seconds | no | Option programming menu 2. For use during installation. | |
|
| |||
|
|
|
|
|
ByFirstech,LLC |
| 10 | 11 |
| ByFirstech,LLC |
|
|