Quick Reference
v @m
When servicing or loaning your vehicle to others, the CompuStar system should be placed in Valet Mode. Valet Mode prevents the system from remote starting and disables all alarm functions.
IMPORTANT: While in Valet mode the CompuStar will still lock and unlock power lock systems.
The system can be put into valet one of two ways;
1. Turn the vehicle’s key to the ignition “on” position and tap buttons (I + III) simultaneously for 0.5 second. The parking lights will flash once and the LCD will display Z’s above the vehicle image to confirm the system is in valet mode. Repeat this process to take the system out of valet mode. The parking lights will flash twice and Z’s will disappear to confirm the system is out of valet mode.
2.If you do not have your remote control, you can put the system into valet by turning the ignition key “on” and then “off” five times within 7 seconds. The parking lights will flash once to confirm the system is in valet mode. Shortly after the first flash, the parking lights will flash twice. A remote control is required to take the system out of valet mode.
If your system is set up for a secure valet option (optional), you will not be able to put the system into valet until the proper code has been entered to the secure valet switch. The secure valet switch is the small button with bright blue LED on the front and if installed is the only way to override the alarm and/or remote start. Until programmed, the default code is (3, 3).
Quick Reference
r @m Mb @r
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing the battery.
Two-Way Remote: Models 2W900FMR-2nd-5P and 2WSHLCDR
First, release the battery cover lock located on the back of the remote. Once the lock is released, gently slide the battery cover off to expose the battery. The
IMPORTANT: Be sure to observe correct polarity when installing the battery.
One-Way Remotes: 1W900FMR and 1WSHR Fiance
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart taking care to not damage the circuit board. The 1W900FMR and 1WSHR requires two 2025 batteries. These specialty batteries can be purchased from your local CompuStar dealer or an electronics store.
ByFirstech,LLC |
| 8 | 9 |
| ByFirstech,LLC |
|
|