Icom IC-910H service manual Software Adjustment, Meter

SOFTWARE ADJUSTMENT (continued)

ADJUSTMENT	ADJUSTMENT CONDITION		DISPLAY	OPERATION
ADJUSTMENT 1	• Enter software	adjustment mode (Refer		Push [RIT] key to store the “S0” level
			USB
ITEM (2)	page 5-12).			into memory, and to step next.
S-METER	• Push [2] key to enter the S-meter adjust-
(MAIN BAND)	ment
	• Connect an SSG to [VHF ANT] connector
	and set as	:
	Frequency	: 146.0200 MHz
	Level	: OFF

•Receiving

2 • Set an SSG as	:		USB	Push [RIT] key to store the “S9” level
Frequency	: 146.0200 MHz			into memor, and to step next.
Level	: 3.2 µV* (–97 dBm)
• Receiving
3 • Set an SSG as	:		USB	Push [RIT] key to store the “S9+60”
Frequency	: 146.0200 MHz			level into memory, and to step next.
Level	: 1 mV* (–47 dBm)
• Receiving
4 • Set an SSG as	:	FM		Push [RIT] key to store the “S0” level
Frequency	: 146.0200 MHz			into memory, and to step next.
Level	: OFF
• Receiving
5 • Set an SSG as	:	FM		Push [RIT] key to store the “S9” level
Frequency	: 146.0200 MHz			into memory, and to step next.
Level	: 3.2 µV* (–97 dBm)
Modulation	: OFF

•Receiving

6	• Set an SSG as	:	FM		Push [RIT] key to store the “S9+60”
	Frequency	: 146.0200 MHz			level into memory, and to step next.
	Level	: 32 µV* (–77 dBm)
	• Receiving
(SUB BAND) 7	• Set an SSG as	:			Push [RIT] key to store the “S0” level
	Frequency	: 146.0200 MHz			into memory, and to step next.
	Level	: OFF	SUB	USB
	• Receiving
8	• Set an SSG as	:			Push [RIT] key to store the “S9” level
	Frequency	: 146.0200 MHz			into memory, and to step next.
	Level	: 3.2 µV* (–97 dBm)	SUB	USB
	• Receiving
9	• Set an SSG as	:			Push [RIT] key to store the “S9+60”
	Frequency	: 146.0200 MHz			level into memory, and to step next.
	Level	: 1 mV* (–47 dBm)	SUB	USB
	• Receiving

*This output level of a standard signal generator (SSG) is indicated as SSG’s open circuit.

5 - 13