4CHANNEL SCANNING
1When you want to scan all channels for a signal, press the MODE key momentarily, three times.
•The FRS, CH, and SCAN icons blink and the transceiver scans the channels from channel 1 to 14.
•All channel codes are turned off during scan.
2When a signal is found on a channel, scan will pause at that channel for 10 seconds.
•To resume scanning before the 10 second timer elapses, press the ▲ or ▼ key.
ENGLISH
3 To end scan and return to normal operation, press the PTT switch.
5 CODE SCANNING
1 When you want to scan all code settings on a single channel, press the MODE key momentarily, four times.
• The FRS, SUB, and SCAN icons blink and the transceiver scans the codes from code 01 to 38.
2 When a signal is found at a code setting, scan will pause at that code for 10 seconds.
• To resume scanning before the 10 second timer elapses, press the ▲ or ▼ key.
3 To end scan and return to normal operation, press the PTT switch.
9
9 | 01.4.12, 9:35 AM |