Cobra Digital MT-900 Calling Another Person, Talking to Another Person, Listening for a Response

Page 4
LIGHT/MAX RANGE button
CALL button

O P E R AT I O N

Calling Another Person

To alert another person that you are calling: 1. Press and release the

CALL button. The other person will hear a 2-second ringing tone.You cannot send

or receive transmissions during the 2-second call tone.

Talking to Another Person

1.Press and hold the TALK

button.

TALK

2. With the microphone

button

about 5 cm (2 inches) from

 

your mouth, speak in a

 

normal voice.

 

3. Release the button when

 

you have finished talking and

 

listen for a response. You

 

cannot receive incoming calls

 

while pressing the TALK button.

 

“Roger Beep”

Confirmation Tone

Your listener will hear an audible tone when you release the TALK button. This alerts the other party that you have finished talking and it is OK for them to speak.

(NOTE: The Roger Beep can be turned off and on, see Advanced Features.)

Listening for a Response

When you have finished talking:

1.Release the TALK button to receive incoming transmissions. The radio is always in Standby mode except when the TALK, CALL, or MODE buttons are pressed.

2.Adjust the volume by rotating the ON-OFF/VOLUME switch.

microTALK® Range

maximum range. Buildings and foliage in the path of the signal can reduce the range. Dense foliage and hilly terrain will further reduce the signal.

Auto Squelch

Your microTALK® radio is equipped with Auto Squelch, which automatically shuts off weak transmissions and unwanted noise due to terrain conditions or if you’ve reached your maximum range limit.

Maximum Range Extender

You can temporarily turn off Auto Squelch, allowing all signals to be received and extending the maximum range of your radio:

1. Press and hold the LIGHT/ MAX RANGE button for

5 seconds. You will hear 2 beeps indicating that

Maximum Range Extender is on.

2.To turn Maximum Range

Extender off, press and hold the LIGHT/MAX RANGE button for 1 second, or change channels.

Using the Lock Function

The Lock function locks the CHANNEL, MODE and ENTER buttons to prevent accidental operation. To use the Lock function:

1.While in Standby mode, press and hold the LOCK button for one second. The Lock icon will blink when the unit is locked. Buttons that are NOT locked are the CALL, LIGHT/MAX RANGE, and TALK buttons, which are all fully functional while the unit is locked.

LOCK

button

Your microTALK® radio has a range of up to 3 km

(2 miles). Your range will vary depending on terrain and conditions. In flat, open country your radio will operate at

2.To unlock buttons, press and release the LOCK button again. The Lock icon disappears and all buttons will be unlocked.

Image 4
Contents Intercom compartment jack Talk buttonLock button Belt clipFeatures of This Product Product InformationCaring for Your microTALK Radio Recharging BatteriesBattery Low Auto Battery SaveSelecting a Channel Selecting a Ctcss Privacy CodeUsing the Lock Function Calling Another PersonTalking to Another Person Roger Beep Confirmation ToneUsing the Mode button Using VOX ModeSetting the VOX Sensitivity Level Programming Memory LocationsUsing the Scan Function Recalling Memory LocationsSelect your desired Repeat to recall other memory locationsSetting Dual Watch Using Call Tones and VibrAlertUsing Private Call Voice Scrambling Changing Call Tone Settings Be in Lock mode during these stepsPress the Mode button until the Dual Watch icon flashes Turning Roger Beep Off and OnWest Cortland Street Chicago, IL 60707 USA Vox Headset Mic Ear Bud Mic with PTTEN 301 489-5 07/2000 EN 300 296-2 v.1.1.1 02/01EN 60065