Cobra Electronics MR HH425LI Tri-Watch Mode, To Program or Edit the Tri-Watch Locations

Page 36

Operating Your Radio

TRI-WATCH Button

TRI and MEM Icons

Channel Up/Down Button

64 English

Advanced Operation

Tri-Watch Mode

Tri-Watchmode gives you one (1) button access to scan a total of three (3) channels of most importance to you. Channel 16 is preprogrammed for you and will always be one (1) of the scanned locations. Two (2) other channels of your choice can be stored in the radio. These channels can be edited and/or recalled for future engagements of the Tri- Watch mode. Tri-Watchwill function in Marine and GMRS Standby modes.

NOTE

The radio must be squelched for Tri-Watchmode to function. See page 40 for Squelch procedure.

To Program or Edit the Tri-Watch Locations:

1.Press and hold the TRI-WATCHbutton for two (2)

seconds to activate Tri-Watch Setup mode. The TRI and MEM icons on the display will turn On.

NOTE

The main channel number will flash to indicate channel position. If there is no input activity for 15 seconds, the radio will sound two (2) beeps and return to Marine or GMRS Standby mode.

2.Press BAND button to select Marine or GMRS for the first Tri-Watchprogrammable channel.

3.Press Channel Up/Down button to select the desired Tri-Watchchannel.

4.Press and release TRI-WATCHbutton or Call/Enter/Setup button to confirm entry.

5.Repeat steps 2 through 4 to select second Tri-Watchprogrammable channel. The radio will scan Marine Channel 16 plus two (2) other selected channels in Marine or GMRS bands.

6. After programming both Tri-Watchmemory channels the radio will immediately engage Tri-Watchmode.

Operating Your Radio

TRI-WATCH Button

Tri-Watch Scan Mode

Advanced Operation

Using Tri-Watch

Tri-Watch Scan Mode:

1.From Marine or GMRS Standby mode, press the

TRI-WATCHbutton. The TRI icon will appear on the LCD display and the radio will scan through the three (3) Tri-Watchmemory channels.

2. A signal on any one (1) of the three (3) channels will stop the scan for 10 seconds to allow you to listen to the traffic on that location.

NOTE

After the Tri-Watchscan stops to monitor a channel, as long as you do not press any buttons within 10 seconds, your radio will automatically resume scanning the Tri-Watchchannels.

3.Press the Channel Up/Down button to resume

scanning the Tri-Watchchannels or to change the scan direction.

4.To EXIT the Tri-Watchscan, press the TRI-WATCH

button again. The TRI icon will disappear from the LCD and the radio will return to Marine or GMRS Standby mode.

Nothing Comes Close to a Cobra® 65

Page 35 Page 37
Image 36
Page 35 Page 37
Contents Our Thanks to You Customer Assistance How Your CobraMarine VHF/GMRS Radio WorksFor Assistance in the U.S.A For Assistance Outside the U.S.ARadio Controls Indicators Backlit LCD Screen Product FeaturesBacklit LCD Liquid Crystal Display Screen Lithium-Ion Rechargeable Battery Pack Signal Strength MeterChannel Scan/Memory Scan Instant Channel 16/9Table of Contents Important Safety Information Safety Training InformationImportant Safety Information Always use only Cobra authorized accessoriesRecommendations for Marine Communication Recommendations for Marine CommunicationVHF Marine FCC Licensing Information Station LicenseInternational Station License Radio Call SignVHF Marine Radio Procedures VHF Marine Voice Calling VHF Marine Voice CallingVessel Corsair is calling the vessel Vagabond VHF Marine Emergency Messages and Distress Procedure VHF Marine Radiotelephone CallsMarine Emergency Signals Three 3 spoken international emergency signals areIf You Hear a Distress Call Marine Distress Procedure Tell where you areSay End message by sayingVHF Marine Channel Assignments International Distress, Safety and Calling 156.700 Rx Only 156.750156.800 156.850 03A Government Only20A Port Operations Port Operations, Ship Movement 21A U.S. Government Only Canada Coast Guard Only23A Government Only 64A U.S. Government Only Canada Commercial Fishing Digital Selective Calling Voice communications not allowed81A U.S. Government Only Environmental Protection Operations Gmrs Communication Gmrs FCC Licensing GMRS/FRS Frequency Allocation and CompatibilityGmrs Communication Gmrs FCC LicensingNoaa Weather Channels Alert Noaa Test Alert SystemNoaa Emergency Weather Alert Weather Frequency/ChannelSpecific Area Message Encoding Same Alerts Included in this PackageSpecific Area Message EncodingSAME Alerts Antenna, Wrist Strap Belt Clip Batteries and ChargerWrist Strap Belt ClipTo Remove Battery Pack from Radio Initial ChargeAlkaline Batteries Power/Volume/Squelch Controls Power On/Off Control Volume ControlGetting Started Common Radio Functions All BandsCall/Enter/Setup Button To Lock or Unlock the Buttons Squelch ControlTalk Button Backlight/Key Lock ButtonHigh/Medium/Low H-M-L Power Button To Toggle Between H-M-L Power ModesCall /Enter/Setup Button Scan ButtonSetup Mode Programming Setup Mode ProgrammingUSA/International/Canada Channel Maps To Set Channel Map Operating AreaVoice Activated Transmit VOX Mode To turn VOX Mode On or OffVibrAlert Mode To set VOX Sensitivity LevelCall Tone Mode Roger Beep ModeKey Tone Mode To Set Call ToneCtcss and DCS Coding Mode To Set Ctcss Code EntryTo Set DCS Code Entry Ctcss and DCS Code Scan Mode To Set Ctcss Code ScanTo Set DCS Code Scan To Set WX Alert On or Off To Set WX Auto Search Scan On or OffTo Set Specific Area Message Encoding Same Alert On or Off Marine VHF Standby Mode Standby/Receive TransmitMarine VHF, Gmrs and WX Alert Standby Band Selections Standby/Receive and TransmitGmrs Standby Mode Transmit Tx and Receive Rx ModesReceive Rx Icon Bar Graph Icon Transmit Tx Icon Bar Graph Icon To Transmit a MessageWeather WX Standby Mode WX Alert Standby ModeWX Auto Search Scan Mode Function WX Auto Search Scan function is OnChannel 16/9 Mode Advanced OperationAdvanced Operation Tri-Watch Mode Using Tri-Watch Tri-Watch Scan ModeTo Program or Edit the Tri-Watch Locations To Exit Memory Location Mode Memory LocationsTo Program Memory Locations To Recall a Stored Memory LocationChannel Scan Mode Memory Location ScanTo Enter Channel Scan Memory locations, seeRewind-Say-Again Feature Using Rewind-Say-AgainUsing Rewind-Say-Again to Record Audio Transmission ExampleMaintenance Troubleshooting SpecificationsMaintenance TroubleshootingProduct Service Product ServiceAccessories AccessoriesLapel Speaker Microphone
Top Page Image Contents