LI4900WX.qxp 11/21/2006 2:19 PM Page 14
Mode Functions
Operation
6.Choose one of the following:
a.Press the Channel Up or Channel Down button to select a CTCSS privacy code (01 through 38) for the channel.
b.Press the Lock/Enter button to switch from CTCSS to DCS. The DCS icon and privacy code numbers will flash on the display. The Channel Up or Channel Down button can then be used to select a DCS privacy code (01 through 83) for the channel.
If “OFF” flashes in place of the privacy code numbers, a privacy code is already set in the opposite (CTCSS
or DCS) system. Press the Channel Up or Channel Down button to cancel the opposite code and select a privacy code from the active system for the selected channel.
7.Choose one of the following:
a.Press the Lock/Enter button to enter the channel/privacy code in the selected memory location. Radio then proceeds to next Memory location, which will blink.
b.Press the Mode button to
enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.
c.Press the Talk button to enter the channel/privacy code in the selected memory location and exit mode functions. Upon release of the Talk button, the radio will enter Standby mode on the channel/privacy code just entered.
Introduction
Mode Button
Memory Icon
Channel Buttons
|
|
|
Operation | Customer Assistance | Warranty |
To recall a stored memory channel location:
1.Press the Mode button until the Memory icon and the memory location number flash on the
display.
2.Press the Channel Up or Channel Down button to select a memory location
(0 through 9).
If a location has been programmed before, its associated channel/privacy code will be shown on the display.
3. Press the Talk button to return to Standby
mode on the selected memory location.
A memory location can be reprogrammed at any time it is displayed and flashing. Press the Lock/Enter button to begin.
While recalling a stored memory location,
if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.
14 | 15 |