Cobra Electronics LI 4900WXC To de-program a memory location, Channel Scan, To scan channels

Page 11

LI4900WX.qxp 11/21/2006 2:19 PM Page 16

Operation

Mode Button

Mode Functions

To de-program a memory location:

1. Press the Mode button until the

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

Channel Scan

•

Your microTALK radio can automatically scan channels.

Memory Icon

Channel Buttons

Lock/Enter Button

Channel 0

Memory icon and the memory location

flash on the display.

2.Press the Channel Up or Channel Down button to select the memory location (0 through 9).

If a location has been programmed before, its associated channel/privacy code will be shown on the display.

3. Press the Lock/Enter button. The channel numbers will flash on the display.

4.Press the Channel Up or Channel Down button to select Channel 0.

5.Choose one of the following:

a.Press the Lock/Enter button to enter the channel/privacy code in the selected memory location and return to the beginning of memory location options.

b.Press the Mode button to

enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions.

While de-programming a memory location,

if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

Mode Button

Scanning Channels

Channel Buttons

To scan channels:

1.Press the Mode button until the Scan icon and the channel numbers flash on the display.

2.Press the Channel Up or Channel Down button to begin scanning channels.

The radio ignores specific privacy codes while scanning channels.

The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds.

While setting channel scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions.

16

17

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Making Life Easier and Safer Limited One-Year Warranty on Radios & Charger Product FeaturesWarranty FeaturesEstimated operation time on full charge 10 hours Replace battery compartment cover and belt clipCaring for Your microTALK Radio Insert radios into desktop charger as shown Using Your RadioListening for a Response To toggle between high and low powerChannels Or Channel Down buttonAuto Squelch/Maximum Range Lock FeatureSignal Strength Meter To turn the lock feature on or offTo select a Ctcss privacy code Mode FunctionsScrolling through Mode Functions Set Ctcss Privacy CodesNOAA* All Hazards Radio Channels Standby modeSet DCS Privacy Codes To select a DCS privacy codeTo set VOX sensitivity To turn VOX mode on or offVoice Activated Transmit VOX Memory LocationsDisplay Press the Mode button toChoose one of the following To recall a stored memory channel locationTo scan channels To de-program a memory locationChannel Scan Privacy Code Scan Press the Mode button to proceed to set privacyPress the Channel Up or Channel Down button to To scan memory locations Memory Location ScanVibrAlert and Call Alert To change call settingsTo change keystroke tones Call Tone SettingsTo change a call tone setting Keystroke TonesGeneral Specifications General SpecificationsFCC Licensing Product Service Questions Safety Information for microTALK Radios Safety and Trademark AcknowledgementProduct Service
Top Page Image Contents