|
|
|
|
|
|
| Introduction | Operation | Customer Assistance | Warranty |
|
Caring for Your microTALK® Radio | • |
|
Your microTALK® radio will give you years of
if cared for properly. Handle the radio gently. Keep the radio away from dust. Never put the radio in water or in a damp place. Avoid exposure to extreme temperatures.
Rechargeable Batteries and Charger | • | ||
Remove Belt Clip To install or replace batteries: | |||
| |||
1. | Remove belt clip by releasing belt clip |
| |
| latch and sliding clip up. |
| |
2. | Pull up on the battery door latch to remove the |
| |
Pull Up Lock Latch | battery compartment cover. |
| |
|
| ||
Insert Batteries
Radio Charger Jack
3.Insert the supplied four AAA rechargeable batteries or
4.Replace battery compartment cover and belt clip.
To charge batteries in radio:
1.Check to see that the batteries have been inserted properly.
2.Insert the wall charger/adapter into the charge jack located at the top of the radio. The wall charger/adapter has two round connectors which enables you to charge either one or two radios at a time.
3.Plug the wall charger/adapter into electrical outlet.
It normally takes 15 hours to fully recharge batteries. It is not recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger/adapter for recharging your Cobra microTALK® radio.
NOTE Do not mix old and new batteries.
Do not mix alkaline, standard
Nothing Comes Close to a Cobra® 1