Cobra Electronics CXT94 owner manual Using Your Radio

Page 4

Using Your Radio

Operation

Speaker/Microphone/Charge Jack

Speaker/Microphone To attach a speaker/microphone:

 

/Charge Jack

1.

Open the speaker/microphone/charge

 

 

 

 

 

tab on top of your microTALK® radio.

 

 

2.

Insert the speaker/microphone accessory

 

 

 

plug into the speaker/microphone/charge jack.

 

To connect a wall charger/adapter:

1.Open the speaker/microphone/charge tab on top of your microTALK® radio.

2.Insert the wall charger/adapter plug

into the speaker/microphone/charge jack.

Quick Start

 

Introduction

 

Customer Assistance

 

Warranty

 

 

Operation

 

 

Battery Low

 

 

When battery power is low, the Battery Low icon

Battery Low

 

 

will blink. Your batteries should be replaced or

 

 

recharged, if using rechargeable batteries.

 

Auto Battery Save

 

 

Battery Save Mode If there are no transmissions within 10 seconds, the

 

radio will automatically switch to Battery Save

 

 

mode and the Power Saver icon will flash in the

 

 

display. This will not affect the radio’s ability to

 

 

receive incoming transmissions.

 

Communicating with Another Person

 

1. Press and hold the Talk button.

Talk Button

 

1. Press and hold the Mode/Power button to turn on your radio.

2.Press the Channel Up or Channel Down button to select a channel.

Both radios must be tuned to the same channel/privacy code to communicate.

3. Press and hold the Talk button while

speaking into the microphone.

Two Inches (5 cm) from Mouth

2.With the microphone about two inches (5 cm) from your mouth, speak in a normal voice.

3.Release the Talk button when you are finished talking and listen for a response.

You cannot receive incoming calls while pressing the Talk button.

Both radios must be tuned to the same channel to communicate.

4. When finished talking, release the Talk

button and listen for a response.

Turning on Your microTALK® Radio

To Select a Channel

 

With the radio on, select any of the

Channel Button

 

 

22 channels by pressing the Channel Up

 

 

or Channel Down button.

 

 

Mode/Power

Press and hold the Mode/Power button until you

 

hear a series of audible tones indicating the radio is

 

on.

Your microTALK® radio is now in Standby mode, ready to receive transmissions. The radio is always

Channel Number

Both radios must be tuned to the same channel to communicate.

Channels 1 through 7 are shared with FRS/ GMRS. Channels 8 through 14 are FRS only. Channels 15 through 22 are GMRS only.

in Standby mode except when the Talk, Call or Mode/Power buttons are pressed.

See page 14 for FRS/GMRS frequency allocations and compatibility charts.

 

 

Nothing Comes Close to a Cobra® 3

2

Image 4
Contents Making Life Easier and Safer Warranty and Trademark Acknowledgement Product FeaturesLimited One-Year Warranty on Radios & Charger Caring for Your microTALK Radio Rechargeable Batteries and ChargerUsing Your Radio To Adjust Volume Listening for a ResponseLock Function To Illuminate DisplaySet Ctcss Privacy Codes Scrolling Through the Mode FunctionPrivacy Codes Set DCS Privacy Codes Mode FunctionsVoice Activated Transmit VOX Channel Scan Roger Beep Confirmation Tone General Specifications Licensing General SpecificationsProduct Service Product Service QuestionsProduct to the store. See customer assistance on page A1 Send the entire product