Cobra Electronics LI 4900WX owner manual Memory Location Scan, To scan memory locations

Page 13

Mode Functions

Operation

During privacy code scan (while receiving an incoming transmission), you can choose from the following:

a. Press and hold the Talkbutton to communicate on that channel/privacy code. Your radio will remain on that channel/privacy code and return to Standby mode.

b. Press the Channel Up or Channel Down button to resume scanning privacy codes.

If you press the Talkbutton while scanning, but more than

 

 

 

 

Introduction

Operation

Customer Assistance

Warranty

Memory Location Scan

Your microTALK radio can automatically scan up to 10 programmed Memory Locations.

If there are one or fewer memory locations programmed in your radio, the scan memory locations option will not be available. To program at least two memory locations, see program memory locations on page 13.

10 seconds after receiving a transmission, you will transmit on the channel/privacy code on which you last received a transmission. This will then return the radio to Standby mode.

If you do not press any button within 10 seconds, your radio will automatically resume scanning privacy codes.

During privacy code scan (while not receiving a transmission), you can choose from the following:

a. Press and hold the Talkbutton to communicate on the channel/privacy code that was displayed before you entered mode functions or the channel/privacy code on which, during scanning, you last received a transmission. This will return the radio to Standby mode.

b. Press the Mode button to proceed to set memory location scan (see page 21 for further details).

c. Press the Lock/Enter button to return to Standby mode on the channel/privacy code that was displayed before you entered mode functions or the channel/ privacy code on which, during scanning, you last received a transmission.

Mode Button

Scanning Locations

Channel Buttons

To scan memory locations:

1.Press the Mode button until the Scan icon, Memory icon and the memory location number flash on the display.

2.Press the ChannelUp or ChannelDown button to begin scanning memory locations.

The Scan icon and the Memory icon will continue to be displayed when memory location scan is on. Your radio will continue to scan memory locations and stop if an incoming transmission is detected. Your radio will remain on that memory location for 10 seconds.

While setting memory location scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions.

20

21

Image 13
Contents For Assistance in the U.S.A Making Life Easier and SaferAutomated Help Desk Customer Assistance OperatorsWarranty and Trademark Acknowledgement Product FeaturesLimited One-Year Warranty on Radios & Charger Trademark AcknowledgementCaring for YourmicroTALKRadio Replace battery compartment cover and belt clipEstimated operation time on full charge 10 hours Battery Low Using Your RadioAuto Battery Save For charging microTALK radios in desktop chargerListening for a Response To toggle between high and low powerCall Button To alert another person that you are calling To Illuminate DisplaySignal Strength Meter Lock FeatureAuto Squelch/Maximum Range MicroTALK RangeScrolling through Mode Functions Mode FunctionsPrivacy Codes Set Ctcss Privacy CodesSet DCS Privacy Codes Standby modeTo select a DCS privacy code NOAA* All Hazards Radio ChannelsVoice Activated Transmit VOX To turn VOX mode on or offMemory Locations To set VOX sensitivityChoose one of the following Press the Mode button toTo recall a stored memory channel location DisplayChannel Scan To de-program a memory locationTo scan channels Press the Channel Up or Channel Down button to Press the Mode button to proceed to set privacyPrivacy Code Scan To scan memory locations Memory Location ScanVibrAlert and Call Alert To change call settingsCall ToneSettings Mode Functions General SpecificationsKeystroke Tones Roger Beep ConfirmationToneGeneral Specifications General Specifications FCC LicenseProduct Service Questions Product Service