Operation | Operation |
|
|
Note
The reading will be slightly higher on Channels 1 and 40 compared to Channel 20.
Note
When switched to SWR position the meter needle should ideally be as far to the left as possible. Anything over 3 is not acceptable. The antenna indicator will light. A slight antenna height adjustment (higher or lower) may be required. Repeat relcalibration steps.
5While still holding down the mic button, set the S/RF SWR CAL switch to the SWR position, to read the SWR reading.
6Repeat the same steps two through five
on Channel 1 and 40. This will check SWR for all channels.
To Receive | To Receive |
|
1Rotate the On/Off Volume knob clockwise the green RX/TX LED will be illuminated.
12 | 13 |