Binatone 950 manual DWWHU\ Phwhu, Important Charge the unit for 10-14 hours

Page 3

d.Place the Action 950 units in the charge cradle in an upright position.

The Charge LED indicators will light up.

e.It takes about 10 hours to fully recharge the batteries if they are completely run down. New batteries take up to 14 hours to fully charge.

Important:

Always turn off the PMR units when charging. This will shorten the charging time.

Mains socket

OR: Charging the batteries (using adaptor)

 

Lift the charge socket cover located on

 

the right side of the handset.

Charge jack

Insert the round connector of the 9.0V DC/200mA adaptor into the charge jack.

Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket set to OFF. Use only the mains adaptor provided.

Mic/Earpiece jack

Then switch ON the mains socket.

%DWWHU\ PHWHU

The battery meter is located in the left corner of the LCD Screen. It appears like a battery with three bars inside. These indicate the amount of power available. When the battery level reaches its minimum level in PMR on mode, the unit will emit two beep tones

and automatically power off.

The Action 950 can detect the battery charge in 4 levels; Battery charge at high level.

Battery charge at medium level.

Battery charge at low level. At this level, the Action 950 will emit a “beep” sound for every 10 seconds in normal mode.

Important: Charge the unit for 10-14 hours.

Battery charge at very low level. When the battery level reachs its minimum level in Action 950 on mode, the unit will emit two beep tones and automatically turn off the power .

Important: Charge the unit for 10-14 hours.

CAUTION : Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

%DWWHU\ OLIH

The Action 950 has a built in power saver to make the batteries last longer. But when you are not using the units, turn them OFF to conserve battery power.

Image 3
Contents PTT Push to Talk button PWR/VOL SwitchLCD Screen LCD ScreenCharging the Batteries InstallationInstalling the Belt Clip Removing the Belt ClipImportant Charge the unit for 10-14 hours DWWHU\ PhwhuTurning the Unit ON/OFF To Turn on To switch OFFSetting the Ctcss sub-channel OperationTransmittingsending speech Setting the DCS Advanced Digital CodeSetting the VOXVoice ActivatedSensitivity ReceivingActivating the Auto Channel Scan Activating the Vibrator modeSetting the Roger Beep Call-Ring toneSpecifications AuxiliaryFeaturesSafety Cleaning and CareChannel Frequency Table Guarantee Troubleshooting Guide Symptom Solution