Transmitter Controls and Functions

Refer to Figures H through Q for an overview of transmitter functions and controls.

Touch: A momentary press of the Mode/Set button. It is used to enter Menu mode, to enter Edit mode, or to Escape without making any changes to current settings.

Hold: A press and hold (about two seconds) of the Mode/Set button. It is used to accept a new setting when the receiver is in Edit mode or to save the current settings to one of the five user-defined name presets or the internal memory location (“NAME?”).

LCD Window

The Liquid Crystal Display presents a great deal of setup and operating information clearly and conveniently (Figure H). The LCD in the transmitters is designed for greatest contrast and best viewing with the window rotated somewhat away from the viewer (about 30 degrees), not straight-on, for a more convenient holding/viewing position.

Power/Mute Button

The transmitters have a combination Power and Mute switch (Figure J/K). When used in combination with the programmed choices explained below, the various functions available to the transmitter user may be tailored to fit personal preferences or particular situations.

Power On/Off

To turn the transmitter on, hold the Power/Mute button until the red power indicator and the LCD window come on (about 1–2 seconds). The operating frequency shows in the window after the power-up sequence.

To turn the transmitter off, hold the Power/Mute button again, until the red power indicator and the LCD window are extinguished (about 1–2 seconds). The LCD window shows “PWR.OFF” before shutdown.

Mute On/Off

When the transmitter is muted, it produces RF with no audio signal modulation. When the transmitter is un-muted, it produces both RF and audio.

To mute the transmitter (cut off the audio, but continue the RF output), touch the Power/Mute button once. A small “MUTE” appears in the LCD window, just below the frequency (Figure H-2).

To un-mute the transmitter (restore the audio), touch the Power/Mute button once again. The “MUTE” disappears from the LCD window.

Figure H

BATT	MIC
	*

BATT	MUTE MIC
	▼

▼
MENU
BATT	MIC

	Flashing
	▼
	EDIT
BATT	MIC

H-1. Normal Operation

* AEW-T1000 only: “INST”

H-2. Operation with Mute On

H-3. Menu Mode (Frequency)

H-4. Edit Mode (Frequency)

Figure J

LCD Window

Power/Mute

Button

Up/Down

Arrows

Sliding Control Cover (3-position)

Antenna

Power-on LED

Audio Input Jack

TRANSMITTERUHFT1000-AEW	Mounting Clip
	Mounting Clip
	Set Button

Battery Door

Figure K

Power/MuteLCD

ButtonWindow

Antenna	Power-on
Housing	LED