Push-To-Talk (PTT) Button (3)
Pressing and holding this button will allow you to speak to any transceiver that is set to the same channel as yours.
Hold the transceiver approximately 1 to 2 inches from your face as you speak into the
After you have finished speaking, release the PTT Button to al- low reception of incoming signals. It is not possible to transmit and receive at the same time. Whenever the PTT Button is pressed the TX icon is displayed on the LCD.
Releasing the button allows the unit to revert to standby mode. When receiving an incoming signal, the RX icon will appear on the display. The PTT Button can also be used as a
Up Channel/Volume Button (10)
In the standby mode, pressing this button increments the listen- ing volume. When in function edit mode, this button is used to adjust the unit’s settings.
Down Channel/Volume Button (11)
In the standby mode, pressing this button decrements the listen- ing volume. When in function edit mode, this button is used to adjust the unit’s settings.
Power/Function (
/F) Button (6)
This button is used to turn on the transceiver; it also provides access to various feature settings in the GMRS and FRS modes.
Scan Button (9)
Press this Button momentarily to enable or disable the scan mode.
8
128-6781
8 of 16