Audiovox GMRS200W owner manual Powering the Transceiver, Charging the Transceiver Battery

Page 5

Powering the Transceiver

Your GMRS200W radio transceiver operates on a Lithium ion (Li-ion) battery.

To install the battery, proceed as follows:

1.Press the release clip lever toward the cover and lift the battery cover up and off at the same time.

2.Insert the Li-ion battery with the contacts facing down and touching the unit contacts.

3.Insert the end tab of the battery cover in the bottom slot and press the top of the cover into position until it clicks into place.

RELEASE	WRIST		POSITIVE
CLIP LEVER	WRIST
	BAND
			TERMINAL
(TOP OF COVER)			TERMINAL
(TOP OF COVER)
BATTERY			NEGATIVE
COVER			TERMINAL
Charging the Transceiver Battery
CHARGING		ADAPTER
LED (RED)		ADAPTER
LED (RED)		PLUG
		PLUG
			PTT/CALL
WALL CHARGING ADAPTER		MIC/CHG/SPK
GMRS2WCH		JACK

NOTE: The battery will fully charge in approximately 10-12 hours. 5

5 of 16

Image 5

Contents Model GMRS200W Gmrs License LCD Model GMRS200W FCC License RequiredModel GMRS200W Display Equipment and Accessories SuppliedInstalling the Batteries Powering the TransceiverCharging the Transceiver Battery Removing Wrist/Arm Straps Installing and Removing Wrist/Arm StrapsInstalling Wrist/Arm Straps Adjusting the Volume Power On/Off 6 ButtonGMRS200W Operational Modes ControlsDown Channel/Volume Button Up Channel/Volume ButtonPower/Function /F Button Push-To-Talk PTT ButtonGRMS/FRS Operation Operating Modes and FeaturesChannel Selection To change the channelChannel Scan Operation VOX Selection ModeRoger Beep Tone Battery AlertKey Tone 128-6781 Problem Probable Cause Remedy TroubleshootingPower Supply Technical SpecificationsGeneral ReceiverMain Channel Frequencies DAY Limited Warranty