Konica Minolta FRS-1000 manual Adapter Charge ON/OFF Switch Plug DC12VBASE Jackunit

Page 7

The battery charge indicator icon displays the battery charge level when the AC adpter is unplugged. When the AC adapter is connected and in use, the indicator icon will indicate a full charge as shown below.

Full Battery - three segments are illuminated.

Low Battery - one segment is illuminated.

Approximately 20–24 hours are required to fully charge the batteries. The red LED charging indicator (14) will light whenever the batteries are charging. A flashing red LED charging indicator denotes batteries are not installed. You must set the CHARGE switch to the OFF position, when using any batteries other than the ones provided. Failure to do this may cause damage to batteries resulting in personal injury and/or damage to the unit.

Caution: The charging adapter is intended for use with the supplied rechargeable Ni-MH batteries Part Number FRSRBAT. Do not attempt to recharge any other type batteries.

AC

ADAPTER

CHARGE

ON/OFF

SWITCH

ADAPTER

PLUG

DC12VBASE

JACKUNIT

7

Image 7
Contents Model FRS-1000 Family Radio Service Model FRS-1000 Model FRS-1000 Display Installing the Back-Up Batteries Charging FRS-1000 Batteries P/N Frsrbat Adapter Charge ON/OFF Switch Plug DC12VBASE Jackunit FRS-1000 Operational Modes Push To Talk PTT Button Power On/Off 16 ButtonAdjusting the Volume Monitor/Display L/MON ButtonScan/Lock Mode Button Up Channel/Volume ButtonDown Channel/Volume Button Mode ButtonFRS Operation Channel Selection Transmit Power Selection Mode Key Tone Dual Watch ModeVOX Selection Mode Call Ringer Selection ModeRoger Beep Tone Scan Operation Ctcss Scan Operation Auto Key Lock Selection ModeWeather Band Operation Weather Alert ModeChannel Selection Additional Functions Problem Possible cause Correction TroubleshootingMatch the setting Technical Specifications General Channel Freq. MHz FRS Channel FrequenciesFreq. Hz Continuous Tone Coded Squelch System Tone Frequencies in HzDAY Limited Warranty