primary line assignment by manually choosing line for your current task.
To assign a primary line, open the menu and select Handset Setup or Base Setup. Select Primary Line, then choose the line you want this station to connect to when it goes off hook:
Line 1 | Always connect to line 1, regardless of either line's status. |
|
|
Line 2 | Always connect to line 2, regardless of either line's status. |
|
|
| Connect to line 1 except under the following circumstances: |
Auto | - there is an incoming call on line 2 |
(default | - there is a holding call on line 2 |
setting) | - line 1 is being used for an active call |
| If any one of these conditions is true, the station connects to line 2. |
|
|
Conferencing two lines together
When you have active calls on both lines, you can join the two lines together in a conference call.
1.Place the first call on hold.
2.Switch to the other line and start the second call.
3.Press MENU, then select Conference. (On the base, you can also press CONFERENCE.)
During a conference call, you can speak with both outside callers at the same time, and the callers can speak with each other.
To separate the conference call back into two independent calls, press the soft key for either line. The other line is automatically put on hold, and you can switch between calls normally.
To disconnect both callers at the same time, just hang up normally.
To disconnect one caller at a time, select the line you want to disconnect, then hang up. Press the soft key to return to the other caller (on hold).
Other stations can also join in the conference call. See Using
21