Uniden DS71 manual DESK/TABLETOP Installation, Set the base on a desk or tabletop with

Page 11

Before connecting your phone line, fully charge the Nickel- Metal Hydride battery pack for 15-20 hours.

Place the power cord so that it does not create a trip hazard or where it could become chafed and create a fire or electrical hazard.

Use only the Uniden AC adaptor supplied with this phone plugged to uninterrupted power supply.

DESK/TABLETOP INSTALLATION

DC IN 9V

TEL LINE

		Line in
	AC	From
	AC	Telephone
	Adaptor	Telephone
	Adaptor	Jack
		Jack

1.	Plug the AC adaptor cord into the 9V DC input jack on the back of the base.
2.	Plug the AC adaptor into a standard 240V AC wall outlet.
3.	Charge the battery (See CHARGING THE BATTERY PACK,
6.	page 15).	INSTALLATION&
6.	Set the base on a desk or tabletop with the	INSTALLATION&
4.	Plug one end of the telephone cord into the TEL LINE jack on the back
	of the base.
5.	Plug the other end of the cord into the
	telephone jack on the wall.	ADJUSTING
	keypad facing up or down then place the	ADJUSTING
	keypad facing up or down then place the

handset into the base. Raise the antenna to a vertical position.

9

Image 11

Contents DS71 Page Contents Do not short-circuit the battery PrecautionsPrecaution This equipment contains a rechargeable Ni-MH batteryImportant Safety Instructions Important Electrical Considerations Additional Battery Safety PrecautionsTelephone Line Problems Welcome Features Introduction Registration Card Included in Your PackageInstallation Considerations InstallingKeypad facing up or down then place DESK/TABLETOP InstallationSet the base on a desk or tabletop with Plug the AC adaptor into a standard 240V AC wall outlet Wall InstallationStandard wall plate mounting Direct wall mounting Retainer holds the handset in placeBe careful not to insert the mounting screws Installation & Adjusting Slide the battery cover forward Until it snaps into place Installing the Handset Battery PackInitial battery charging Charging the Battery PackLow battery indicator Cleaning the Battery ContactsHandset earpiece volume Adjusting the Volume ControlsAdjusting Ringer Tone Handset ringer volumePull back on the release tab and lift the beltclip up Installing the BeltclipTo attach the beltclip To remove the beltclipAutomatic Digital Code Security Headset InstallationTo reset the digital security code Digital security code is resetBasic phone operation UsingMaking and Receiving Calls For New Zealand Version Call WaitingFor Australian Version Talk to the second callerPress mem . The talk LED blinks Using the memory location featuresMute Dialing a Number in MemoryPabx Connection Chain DialingTravelling OUT-OF-RANGE Quick Reference Chart TroubleshootingNo power on Handset SpecificationsGeneral Base UnitWarranty WarrantyControls & Functions 2129 Thank YOU for Purchasing a Uniden Phone