Uniden DS71 manual Troubleshooting, Quick Reference Chart

Page 26

TROUBLESHOOTING

YOUR NEW PHONE

QUICK REFERENCE CHART

If your phone is not performing to your expectations, please try these simple steps first before calling Uniden customer service.

PROBLEM

 

SUGGESTION

 

 

 

Make sure the AC adaptor is plugged into the base and

The charge light

 

wall outlet.

won’t come on

Make sure the handset is properly seated

when the handset

 

in base.

is placed on

Make sure the charging contacts on the handset and base

the base.

 

are clean.

 

 

 

Make sure that the base antenna is in a vertical position.

The audio sounds

Move the handset and/or base to a different location away

 

from metal objects or appliances and try again.

weak and/or

 

 

 

scratchy

 

 

 

 

 

Check both ends of the base telephone

 

 

line cord.

 

Make sure the AC adaptor is plugged into the base and

Can’t make or

 

wall outlet.

Disconnect the AC adaptor for a few minutes, then

receive calls.

 

reconnect it.

 

 

 

Place the handset back on the charging cradle for a few

 

 

seconds. The talk and in use LEDs blinks

 

 

momentarily indicating that the phone has been reset.

 

 

 

The Ni-MH battery pack may be weak. Charge the battery

 

 

for 15-20 hours.

 

Be sure the antenna is in a vertical position.

The handset

The handset may be too far away from the base. Place the

 

base away from appliances or metal objects.

doesn’t ring or

Place the handset back on the charging cradle for a few

receive a page.

 

seconds. The in use LED lights indicating that the

 

 

 

 

phone has been reset.

 

You may have exceeded the REN limit. See MORE THAN

 

 

ONE PHONE on page 5.

 

 

 

24

Image 26
Contents DS71 Page Contents This equipment contains a rechargeable Ni-MH battery PrecautionsPrecaution Do not short-circuit the batteryImportant Safety Instructions Additional Battery Safety Precautions Important Electrical ConsiderationsTelephone Line Problems Welcome FeaturesIntroduction Included in Your Package Registration CardInstalling Installation ConsiderationsKeypad facing up or down then place DESK/TABLETOP InstallationSet the base on a desk or tabletop with Plug the AC adaptor into a standard 240V AC wall outlet Wall InstallationStandard wall plate mounting Retainer holds the handset in place Direct wall mountingBe careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Slide the battery cover forward Until it snaps into placeCharging the Battery Pack Initial battery chargingCleaning the Battery Contacts Low battery indicatorHandset ringer volume Adjusting the Volume ControlsAdjusting Ringer Tone Handset earpiece volumeTo remove the beltclip Installing the BeltclipTo attach the beltclip Pull back on the release tab and lift the beltclip upDigital security code is reset Headset InstallationTo reset the digital security code Automatic Digital Code SecurityBasic phone operation UsingMaking and Receiving Calls Talk to the second caller Call WaitingFor Australian Version For New Zealand VersionDialing a Number in Memory Using the memory location featuresMute Press mem . The talk LED blinksPabx Connection Chain DialingTravelling OUT-OF-RANGE Troubleshooting Quick Reference ChartNo power on Base Unit SpecificationsGeneral HandsetWarranty WarrantyControls & Functions 2129 Thank YOU for Purchasing a Uniden Phone