Uniden DS71 manual Specifications, General, Base Unit, Handset

Page 28

SPECIFICATIONS

YOUR NEW PHONE

GENERAL

Australian Specification: The DS71 complies with TS001, TS002, TS004, AS/NZS 3260 and FCC Part 15(as per ACA Radio Communications Class Licensing Requirements).

New Zealand Specification: The DS71 complies with PTC200, RFS 29.

Frequency control: PLL

Modulation: Direct Sequence Spread Spectrum; DBPSK

Operating temperature: 0º to +50º C

BASE UNIT

Frequency: 917.4 to 925.8 MHz (15 channels: Australia)

Frequency: 923.4 to 927.0 MHz (7 channels: New Zealand)

Power requirements: 9V 300mA (from AC adaptor)

Size: 152mm (W) x 183mm (H) x 53.5mm (D)

Weight: Approx. 307g

HANDSET

Frequency: 917.4 to 925.8 MHz (15 channels: Australia)

Frequency: 923.4 to 927.0 MHz (7 channels: New Zealand)

Power requirements: Rechargeable NiMH battery pack

Size (without antenna): 50mm (W) x 154mm (H) x 27.5mm (D)

Weight: Approx. 136g (including battery)

Battery:

Capacity

550 mAH, 3.6V

 

Talk mode

4 hours

 

Standby mode

14days

Specifications, features, and availability of optional accessories are all subject to change without prior notice.

26

Image 28
Contents DS71 Page Contents Precautions PrecautionThis equipment contains a rechargeable Ni-MH battery Do not short-circuit the batteryImportant Safety Instructions Additional Battery Safety Precautions Important Electrical ConsiderationsTelephone Line Problems Introduction FeaturesWelcome Included in Your Package Registration CardInstalling Installation ConsiderationsSet the base on a desk or tabletop with DESK/TABLETOP InstallationKeypad facing up or down then place Standard wall plate mounting Wall InstallationPlug the AC adaptor into a standard 240V AC wall outlet Retainer holds the handset in place Direct wall mountingBe careful not to insert the mounting screws Installation & Adjusting Installing the Handset Battery Pack Slide the battery cover forward Until it snaps into placeCharging the Battery Pack Initial battery chargingCleaning the Battery Contacts Low battery indicatorAdjusting the Volume Controls Adjusting Ringer ToneHandset ringer volume Handset earpiece volumeInstalling the Beltclip To attach the beltclipTo remove the beltclip Pull back on the release tab and lift the beltclip upHeadset Installation To reset the digital security codeDigital security code is reset Automatic Digital Code SecurityMaking and Receiving Calls UsingBasic phone operation Call Waiting For Australian VersionTalk to the second caller For New Zealand VersionUsing the memory location features MuteDialing a Number in Memory Press mem . The talk LED blinksTravelling OUT-OF-RANGE Chain DialingPabx Connection Troubleshooting Quick Reference ChartNo power on Specifications GeneralBase Unit HandsetWarranty WarrantyControls & Functions 2129 Thank YOU for Purchasing a Uniden Phone