) With the phone in standby, press [Menu/Select]. Select the HANDSET SETUP menu, and then the SELECT BASE submenu.
2)Move the cursor to select the base you want to connect to, or choose AUTO to have the handset automatically select the base.
3)Press [Menu/Select]. SEARCHING will appear in the display.
4)When the base is found, the handset will return to standby. If the base is not found, “SEARCHING” continues to appear. You can repeat the procedure listed above to return back to the original connection or to find the different base.
Note: You cannot change bases during a call.
Setting Up the Phonebook
Your handset can store up to seventy names and numbers in your phonebook. When all the phonebook entries are full, you will hear a beep and MEMORY FULL appears. You cannot store any additional names and numbers unless you delete some of the existing ones.
You can also use the phonebook entries to store a group of numbers (up to twenty digits) that you may need to enter once your call connects. This is referred to as chain dialing. See Chain Dialing from the Phonebook on page 29.
Creating Phonebook Entries
To store names and numbers in your phonebook, please follow these steps:
) When the phone is in standby mode, press [ | ] (on the left side of the four- |
way key). | Edit Name |
| ｡ |
2) To create a new phonebook entry, press [Menu/Select]. Select the CREATE NEW menu. EDIT NAME appears.
3)Enter the name for this entry (EDIT NAME).
Use the keypad to enter a name for this entry; the name can contain up to sixteen characters. (See Entering Text from Your Handset on page 11 for instructions on entering text.) If you do not want to enter a name for this entry, your phone will store this entry as <NO NAME>. Press [Menu/Select] when you are finished.
22