Adjusting the Audio Tone
If you aren’t satisfied with the audio quality of your phone, you can adjust the Audio Tone of the earpiece while on a call. Your phone gives you three audio tone options: low, natural and high; the default setting, Natural Tone, is recommended for hearing aid users. Audio tone adjustments only apply to the earpiece, not the speakerphone.
To adjust the audio tone:
) While on a call, press [Menu/Select].
2)Move the cursor to select AUDIO TONE, and then press [Menu/Select].
3)Move the cursor to select desired option (HIGH TONE, NATURAL TONE, or LOW TONE), and then press [Menu/Select]. Selected option appears in the display for two seconds, and then the display returns to normal.
Finding a Lost Handset
To locate a misplaced handset, press [find hs] on the base when the phone is in standby. The handsets connected to the paging base will beep for one minute, and PAGING appears on the handset display. To cancel paging, press [find hs] again or any key on the found handset.
Note: Handsets that are not currently connected to this base will not be paged.
Using Hold, Conference and Transfer
Placing a Call on Hold
) During a call, press [Clear/Int’com] on the handset to place the caller on hold. If you leave a caller on hold for more than ten seconds, the display screen will read, Line On Hold.
2) To return to the party on hold, press [
/Flash] or [
] on a handset. The phone will return to the holding party.
Notes: • You can only place a caller on hold for five minutes. Once five minutes has passed, that party’s line will be disconnected and the phone will return to standby.
• While a call is on hold, Caller ID and Call Waiting cannot be received.
33