Resetting the Handset Without the Base
If your original base is not available for some reason, you can still reset the handset and use it with another base.
) Press and hold [
] and [#] for at least five seconds.
2)Move the cursor to select BASEUNAVAILABLE and then press [Menu/Select]. BASE UNAVAILABLE appears.
3)Select the base which you want to
4)Move the cursor to select YES, and then press [Menu/Select]. You hear a confirmation tone, and the handset deletes its own base information without contacting the base. If the handset was registered to only one base, it displays HANDSET NOT
5)Register the handset to the new base (see Registering Accessory Handsets on page 20).
Traveling Out of Range
During a call, if you move your handset too far from your base, noise may increase. If you pass the range limit of the base, the handset will beep, display OUT OF RANGE, and then go to standby. The base will maintain the connection for thirty seconds after the handset goes out of range. If you move the handset back within range of the base within thirty seconds, press [
/Flash] or [
] to pick up the call again.
Note: If it is set to automatically select the available base, the handset will begin searching for another base thirty seconds after going out of range. (see Selecting the Base on page 21).
49