Uniden DXC834, DX834 important safety instructions Setting the Handset Retainer

Page 10

Setting the Handset Retainer

The handset retainer holds the Handset in place if your phone is mounted on a wall. The steps below describe how to remove and replace the retainer so that the tab faces up.

1.Push up on the Handset

retainer on the Base Unit, and slide the tab out.

2.Flip the

retainer over so the tab faces up.

3.Put the retainer back into its slot on the Base Unit.

4.Push down on the Handset retainer until it snaps into place.

10	DX834/DXC834

Image 10

Contents Contents Important Safety Instructions DX834/DXC834Battery Safety Precautions Introduction FeaturesIncluded with the DX834/DXC834 Phone Important Electrical Considerations Applying Power to the Base Unit InstallationConnecting the Telephone Cords Selecting a LocationDesk or Tabletop Installation Direct Wall Mounting Wall InstallationStandard Wall Plate Mounting DX834/DXC834 Setting the Handset Retainer Installing the Handset Battery Pack Setting Up Your PhoneExtending the Antenna Initial Battery Charging Cleaning the Battery ContactsCharging the Battery Pack Charging from the Charging CradleBattery Memory Effect To Avoid this Memory EffectAdjusting Ringer Controls Low Battery IndicatorSetting the Pulse/Tone Switch Adjusting Handset Receiver VolumeMaking and Receiving Calls Using Your PhoneChanging Channels, Flash, and Page/Find This Page Intentionally Blank Programming Your Phone Storing a Number in MemoryP3300 Storing a Mixed NumberDialing a Stored Number Chain DialingErasing a Stored Number Troubleshooting Base Unit SpecificationsHandset Addendum to Specifications Precautions Controls and Functions Base Controls and Functions Handset One-Year Limited Warranty Covered under one or more of the following U.S Patents