Low Battery Indicator
When the Battery Pack in the Handset is very low and needs to be charged, the TALK/BATT LOW LED flashes.
If the TALK/BATT LOW LED begins to flash, the phone is programmed to eliminate its functions to save power. The table below describes what to do to return your phone to normal operation.
During a Call | In Standby Mode |
|
|
Only the T button operates. | None of the buttons will |
| operate. |
The Handset beeps and the | The Handset TALK/BATT |
TALK/BATT LOW LED flashes | LOW LED flashes once |
once every 3 seconds. | every 3 seconds. |
Complete your call as | You will not be able to make |
quickly as possible. | a call. |
|
|
Return the Handset to the | Return the Handset to the |
Base Unit for charging. | Base Unit for charging. |
|
|
Note: Allow 15 to 20 hours without any interruption for the Handset to fully recharge.
Setting the Pulse/Tone Switch
Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone company if you are not sure whether your system is Tone or Pulse dialing.
Adjusting Ringer Controls
To adjust the ringer volume of your Handset, press
Gwhen the phone is not in use.
You can also select one of two different ringer tones for the Handset.
Press G to select a different ringer tone when the phone is not in use.
Adjusting Handset Receiver Volume
Volume settings are Normal and High. When the Handset is first picked up, the volume will be at the normal setting. Pressing the V will change the volume to High. This can be accomplished during a call.
Automatic Digital Code Security
To avoid unauthorized calls on your phone, a Digital Code feature was added to the DX834 phone. This Digital Code is shared only between the Handset and Base Unit. The Code is set automatically when you first use the phone.
To change the Digital Code:
1.Be sure the Handset is on the Base then:
2.Press the PAGE/FIND button on the Base Unit. The Handset begins beeping.
3.When the
beeping stops, remove the Handset for 5 seconds, and then return it to the Base Unit.
Note: The Status LED will blink to indicate that the Digital Security Code is set to one of the more than 65,000 codes.
If the Base Unit loses power while the Handset is off the Base, the Digital Code may be erased. When this happens, the Handset will not function. To reestablish communication between the Handset and Base Unit:
1.Restore power to the Base Unit.
2.Place the Handset back on the Base Unit.
3.The Status LED will blink to indicate that the Digital Security Code is set.
14 | DX834/DXC834 |