Uniden DSS7815, DSS7815 +1 Series, DSS7815 Series Getting Started, Connect the base unit

B. Connect the base unit

1) Connect the AC adapter to the DC IN 9V jack and to a standard 240VAC wall outlet. Connect the AC adapter to a continuous power supply (i.e., an outlet that is not controlled by a switch).

2) Set the base on a desk or tabletop, and place the handset in the base unit. Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

3) Make sure that the charge LED illuminates. If the LED does not illuminate, check to see that the AC adapter is plugged in and the handset makes good contact with the base charging contacts.

4) After install the battery pack in the handset, charge your handset for at least 15-20 hours before plugging into the phone line.

5) Once the handset battery pack is fully charged, connect the telephone line cord to the TEL LINE jack and to a telephone outlet. If your telephone outlet isn't modular, contact your telephone company for assistance.

[10]

￿Use only the supplied [AAD- 041S] AC adapter. Do not use any other AC adapter.

￿Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard.

GETTING STARTED